[RFC PATCH v11 01/10] dt-bindings: rockchip-sfc: Bindings for Rockchip serial flash controller

[Rob Herring]

On Wed, Jul 07, 2021 at 05:08:01PM +0800, Jon Lin wrote:
> From: Chris Morgan <macromorgan at hotmail.com>
> 
> Add bindings for the Rockchip serial flash controller. New device
> specific parameter of rockchip,sfc-no-dma included in documentation.
> 
> Signed-off-by: Chris Morgan <macromorgan at hotmail.com>
> Signed-off-by: Jon Lin <jon.lin at rock-chips.com>
> ---
> 
> Changes in v11: None
> Changes in v10: None
> Changes in v9: None
> Changes in v8:
> - Fix indent 4 to 2 in yaml

Sigh, my comments from v7 still remain. I told you the same thing on v8.

> 
> Changes in v7:
> - Fix up the sclk_sfc parent error in rk3036
> - Unify to "rockchip,sfc" compatible id because all the feature update
>   will have a new IP version, so the driver is used for the SFC IP in
>   all SoCs
> - Change to use node "sfc" to name the SFC pinctrl group
> - Add subnode reg property check
> - Add rockchip_sfc_adjust_op_size to workaround in CMD + DUMMY case
> - Limit max_iosize to 32KB
> 
> Changes in v6:
> - Add support in device trees for rv1126(Declared in series 5 but not
>   submitted)
> - Change to use "clk_sfc" "hclk_sfc" as clock lable, since it does not
>   affect interpretation and has been widely used
> - Support sfc tx_dual, tx_quad(Declared in series 5 but not submitted)
> - Simplify the code, such as remove "rockchip_sfc_register_all"(Declared
>   in series 5 but not submitted)
> - Support SFC ver4 ver5(Declared in series 5 but not submitted)
> - Add author Chris Morgan and Jon Lin to spi-rockchip-sfc.c
> - Change to use devm_spi_alloc_master and spi_unregister_master
> 
> Changes in v5:
> - Add support in device trees for rv1126
> - Support sfc tx_dual, tx_quad
> - Simplify the code, such as remove "rockchip_sfc_register_all"
> - Support SFC ver4 ver5
> 
> Changes in v4:
> - Changing patch back to an "RFC". An engineer from Rockchip
>   reached out to me to let me know they are working on this patch for
>   upstream, I am submitting this v4 for the community to see however
>   I expect Jon Lin (jon.lin at rock-chips.com) will submit new patches
>   soon and these are the ones we should pursue for mainlining. Jon's
>   patch series should include support for more hardware than this
>   series.
> - Clean up documentation more and ensure it is correct per
>   make dt_binding_check.
> - Add support in device trees for rk3036, rk3308, and rv1108.
> - Add ahb clock (hclk_sfc) support for rk3036.
> - Change rockchip_sfc_wait_fifo_ready() to use a switch statement.
> - Change IRQ code to only mark IRQ as handled if it handles the
>   specific IRQ (DMA transfer finish) it is supposed to handle.
> 
> Changes in v3:
> - Changed the name of the clocks to sfc/ahb (from clk-sfc/clk-hsfc).
> - Changed the compatible string from rockchip,sfc to
>   rockchip,rk3036-sfc. A quick glance at the datasheets suggests this
>   driver should work for the PX30, RK180x, RK3036, RK312x, RK3308 and
>   RV1108 SoCs, and possibly more. However, I am currently only able
>   to test this on a PX30 (an RK3326). The technical reference manuals
>   appear to list the same registers for each device.
> - Corrected devicetree documentation for formatting and to note these
>   changes.
> - Replaced the maintainer with Heiko Stuebner and myself, as we will
>   take ownership of this going forward.
> - Noted that the device (per the reference manual) supports 4 CS, but
>   I am only able to test a single CS (CS 0).
> - Reordered patches to comply with upstream rules.
> 
> Changes in v2:
> - Reimplemented driver using spi-mem subsystem.
> - Removed power management code as I couldn't get it working properly.
> - Added device tree bindings for Odroid Go Advance.
> 
> Changes in v1:
> hanges made in this new series versus the v8 of the old series:
> - Added function to read spi-rx-bus-width from device tree, in the
>   event that the SPI chip supports 4x mode but only has 2 pins
>   wired (such as the Odroid Go Advance).
> - Changed device tree documentation from txt to yaml format.
> - Made "reset" message a dev_dbg from a dev_info.
> - Changed read and write fifo functions to remove redundant checks.
> - Changed the write and read from relaxed to non-relaxed when
>   starting the DMA transfer or reading the DMA IRQ.
> - Changed from dma_coerce_mask_and_coherent to just
>   dma_set_mask_and_coherent.
> - Changed name of get_if_type to rockchip_sfc_get_if_type.
> 
>  .../devicetree/bindings/spi/rockchip-sfc.yaml | 88 +++++++++++++++++++
>  1 file changed, 88 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
> 
> diff --git a/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml b/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
> new file mode 100644
> index 000000000000..162993a97290
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
> @@ -0,0 +1,88 @@
> +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
> +%YAML 1.2
> +---
> +$id: http://devicetree.org/schemas/spi/rockchip-sfc.yaml#
> +$schema: http://devicetree.org/meta-schemas/core.yaml#
> +
> +title: Rockchip Serial Flash Controller (SFC)
> +
> +maintainers:
> +  - Heiko Stuebner <heiko at sntech.de>
> +  - Chris Morgan <macromorgan at hotmail.com>
> +
> +allOf:
> +  - $ref: spi-controller.yaml#
> +
> +properties:
> +  compatible:
> +    oneOf:

Don't need oneOf when there is only one.

> +      - const: rockchip,sfc

As I mentioned in v7, add a comment here why a non-specific compatible 
string is okay here.

> +
> +  reg:
> +    maxItems: 1
> +
> +  interrupts:
> +    maxItems: 1
> +
> +  clocks:
> +    items:
> +      - description: Bus Clock
> +      - description: Module Clock
> +
> +  clock-names:
> +    items:
> +      - const: clk_sfc
> +      - const: hclk_sfc
> +
> +  power-domains:
> +    maxItems: 1
> +
> +  rockchip,sfc-no-dma:
> +    description: Disable DMA and utilize FIFO mode only
> +    type: boolean
> +
> +patternProperties:
> +  "^flash@[0-3]$":
> +    type: object
> +    properties:
> +      reg:
> +        minimum: 0
> +        maximum: 3
> +
> +required:
> +  - compatible
> +  - reg
> +  - interrupts
> +  - clocks
> +  - clock-names
> +
> +unevaluatedProperties: false
> +
> +examples:
> +  - |
> +    #include <dt-bindings/clock/px30-cru.h>
> +    #include <dt-bindings/interrupt-controller/arm-gic.h>
> +    #include <dt-bindings/power/px30-power.h>
> +
> +    sfc: spi at ff3a0000 {
> +        compatible = "rockchip,sfc";
> +        reg = <0xff3a0000 0x4000>;
> +        interrupts = <GIC_SPI 56 IRQ_TYPE_LEVEL_HIGH>;
> +        clocks = <&cru SCLK_SFC>, <&cru HCLK_SFC>;
> +        clock-names = "clk_sfc", "hclk_sfc";
> +        pinctrl-0 = <&sfc_clk &sfc_cs &sfc_bus2>;
> +        pinctrl-names = "default";
> +        power-domains = <&power PX30_PD_MMC_NAND>;
> +        #address-cells = <1>;
> +        #size-cells = <0>;
> +
> +        flash at 0 {
> +            compatible = "jedec,spi-nor";
> +            reg = <0>;
> +            spi-max-frequency = <108000000>;
> +            spi-rx-bus-width = <2>;
> +            spi-tx-bus-width = <2>;
> +        };
> +    };
> +
> +...
> -- 
> 2.17.1
> 
> 
> 
>