[PATCH v3 2/7] soc: rockchip: io-domain: add rk3568 support
jay.xu at rock-chips.com
jay.xu at rock-chips.com
Fri Aug 6 02:46:05 PDT 2021
Hi Heiko and Robin
--------------
jay.xu at rock-chips.com
>Hi Robin,
>
>Am Donnerstag, 5. August 2021, 18:27:36 CEST schrieb Robin Murphy:
>> On 2021-08-05 13:01, Michael Riesch wrote:
>> > From: Jianqun Xu <jay.xu at rock-chips.com>
>> >
>> > The io-domain registers on RK3568 SoCs have three separated bits to
>> > enable/disable the 1.8v/2.5v/3.3v power.
>> >
>> > This patch make the write to be a operation, allow rk3568 uses a private
>> > register set function.
>> >
>> > Since the 2.5v is not used on RK3568, so the driver only set
>>
>> FWIW, this seems at odds with what the first paragraph says - can anyone
>> clarify what exactly "not used" means here? Is it that the I/O domain
>> controller has been redesigned to support more than two logic levels on
>> the new generation of SoCs, but RK3568's I/O pads still only physically
>> support 1.8v and 3.3v; or is it that it *can* support 2.5v as well but
>> no currently-known RK3568-based designs use that?
>>
>> In the former case it's just a wording issue in the commit message, but
>> in the latter it's arguably worth implementing support now for the sake
>> of future compatibility.
>
>I hadn't looked that deeply into the rk356x io-domain config, but at least
>on a register level in the TRM it seems there are separate bits for
>"3.3V control", "2.5V control", "1.8V control" [0] for each io-domain.
>
>Of course the documentation is otherwise somewhat sparse.
>
>Maybe Jay or Kever [added] can explain a bit more about the 3 voltage
>levels.
>
>
>In general though, I tend to find the approach good enough for now.
>
>Especially as the io-domain stuff is always said to "can cause damage
>to the soc if used incorrectly" and it looks like nobody (including
>Rockchip) seems to have actual hardware using these 2.5V levels right now.
>
>So having code in there that no-one ever tested doesn't feel too good ;-)
>
yes
about the 3bit
case V33 V25 V18 result
0 0 0 0 IO safe, but cannot work
1 0 0 1 IO require 1.8V, should < 1.98V, otherwise IO may damage
2 0 1 0 IO require 2.5V, should < 2.75V, otherwise IO may damage
3 0 1 1 Invalid state, should avoid
4 1 0 0 IO require 3.3V, should < 3.63V, otherwise IO may damage
5 1 0 1 IO require 1.8V, should < 1.98V, otherwise IO may damage
6 1 1 0 IO require 2.5V, should < 2.75V, otherwise IO may damage
7 1 1 1 Invalid state, should avoid
>Adding this later when needed should be somewhat easy, as it really only
>needs adding of handling that 3rd control bit per domain.
>
>
>Heiko
>
>
>
>[0] what happens if none of the 3 is active? ;-)
>
>
>>
>> Robin.
>>
>> > 1.8v [enable] + 3.3v [disable] for 1.8v mode
>> > 1.8v [disable] + 3.3v [enable] for 3.3v mode
>> >
>> > There is not register order requirement which has been cleared by our IC
>> > team.
>> >
>> > Signed-off-by: Jianqun Xu <jay.xu at rock-chips.com>
>> > ---
>> > drivers/soc/rockchip/io-domain.c | 88 +++++++++++++++++++++++++++++---
>> > 1 file changed, 80 insertions(+), 8 deletions(-)
>> >
>> > diff --git a/drivers/soc/rockchip/io-domain.c b/drivers/soc/rockchip/io-domain.c
>> > index cf8182fc3642..13c446fd33a9 100644
>> > --- a/drivers/soc/rockchip/io-domain.c
>> > +++ b/drivers/soc/rockchip/io-domain.c
>> > @@ -51,13 +51,11 @@
>> > #define RK3399_PMUGRF_CON0_VSEL BIT(8)
>> > #define RK3399_PMUGRF_VSEL_SUPPLY_NUM 9
>> >
>> > -struct rockchip_iodomain;
>> > +#define RK3568_PMU_GRF_IO_VSEL0 (0x0140)
>> > +#define RK3568_PMU_GRF_IO_VSEL1 (0x0144)
>> > +#define RK3568_PMU_GRF_IO_VSEL2 (0x0148)
>> >
>> > -struct rockchip_iodomain_soc_data {
>> > - int grf_offset;
>> > - const char *supply_names[MAX_SUPPLIES];
>> > - void (*init)(struct rockchip_iodomain *iod);
>> > -};
>> > +struct rockchip_iodomain;
>> >
>> > struct rockchip_iodomain_supply {
>> > struct rockchip_iodomain *iod;
>> > @@ -66,13 +64,62 @@ struct rockchip_iodomain_supply {
>> > int idx;
>> > };
>> >
>> > +struct rockchip_iodomain_soc_data {
>> > + int grf_offset;
>> > + const char *supply_names[MAX_SUPPLIES];
>> > + void (*init)(struct rockchip_iodomain *iod);
>> > + int (*write)(struct rockchip_iodomain_supply *supply, int uV);
>> > +};
>> > +
>> > struct rockchip_iodomain {
>> > struct device *dev;
>> > struct regmap *grf;
>> > const struct rockchip_iodomain_soc_data *soc_data;
>> > struct rockchip_iodomain_supply supplies[MAX_SUPPLIES];
>> > + int (*write)(struct rockchip_iodomain_supply *supply, int uV);
>> > };
>> >
>> > +static int rk3568_iodomain_write(struct rockchip_iodomain_supply *supply, int uV)
>> > +{
>> > + struct rockchip_iodomain *iod = supply->iod;
>> > + u32 is_3v3 = uV > MAX_VOLTAGE_1_8;
>> > + u32 val0, val1;
>> > + int b;
>> > +
>> > + switch (supply->idx) {
>> > + case 0: /* pmuio1 */
>> > + break;
>> > + case 1: /* pmuio2 */
>> > + b = supply->idx;
>> > + val0 = BIT(16 + b) | (is_3v3 ? 0 : BIT(b));
>> > + b = supply->idx + 4;
>> > + val1 = BIT(16 + b) | (is_3v3 ? BIT(b) : 0);
>> > +
>> > + regmap_write(iod->grf, RK3568_PMU_GRF_IO_VSEL2, val0);
>> > + regmap_write(iod->grf, RK3568_PMU_GRF_IO_VSEL2, val1);
>> > + break;
>> > + case 3: /* vccio2 */
>> > + break;
>> > + case 2: /* vccio1 */
>> > + case 4: /* vccio3 */
>> > + case 5: /* vccio4 */
>> > + case 6: /* vccio5 */
>> > + case 7: /* vccio6 */
>> > + case 8: /* vccio7 */
>> > + b = supply->idx - 1;
>> > + val0 = BIT(16 + b) | (is_3v3 ? 0 : BIT(b));
>> > + val1 = BIT(16 + b) | (is_3v3 ? BIT(b) : 0);
>> > +
>> > + regmap_write(iod->grf, RK3568_PMU_GRF_IO_VSEL0, val0);
>> > + regmap_write(iod->grf, RK3568_PMU_GRF_IO_VSEL1, val1);
>> > + break;
>> > + default:
>> > + return -EINVAL;
>> > + };
>> > +
>> > + return 0;
>> > +}
>> > +
>> > static int rockchip_iodomain_write(struct rockchip_iodomain_supply *supply,
>> > int uV)
>> > {
>> > @@ -136,7 +183,7 @@ static int rockchip_iodomain_notify(struct notifier_block *nb,
>> > return NOTIFY_BAD;
>> > }
>> >
>> > - ret = rockchip_iodomain_write(supply, uV);
>> > + ret = supply->iod->write(supply, uV);
>> > if (ret && event == REGULATOR_EVENT_PRE_VOLTAGE_CHANGE)
>> > return NOTIFY_BAD;
>> >
>> > @@ -398,6 +445,22 @@ static const struct rockchip_iodomain_soc_data soc_data_rk3399_pmu = {
>> > .init = rk3399_pmu_iodomain_init,
>> > };
>> >
>> > +static const struct rockchip_iodomain_soc_data soc_data_rk3568_pmu = {
>> > + .grf_offset = 0x140,
>> > + .supply_names = {
>> > + "pmuio1",
>> > + "pmuio2",
>> > + "vccio1",
>> > + "vccio2",
>> > + "vccio3",
>> > + "vccio4",
>> > + "vccio5",
>> > + "vccio6",
>> > + "vccio7",
>> > + },
>> > + .write = rk3568_iodomain_write,
>> > +};
>> > +
>> > static const struct rockchip_iodomain_soc_data soc_data_rv1108 = {
>> > .grf_offset = 0x404,
>> > .supply_names = {
>> > @@ -469,6 +532,10 @@ static const struct of_device_id rockchip_iodomain_match[] = {
>> > .compatible = "rockchip,rk3399-pmu-io-voltage-domain",
>> > .data = &soc_data_rk3399_pmu
>> > },
>> > + {
>> > + .compatible = "rockchip,rk3568-pmu-io-voltage-domain",
>> > + .data = &soc_data_rk3568_pmu
>> > + },
>> > {
>> > .compatible = "rockchip,rv1108-io-voltage-domain",
>> > .data = &soc_data_rv1108
>> > @@ -502,6 +569,11 @@ static int rockchip_iodomain_probe(struct platform_device *pdev)
>> > match = of_match_node(rockchip_iodomain_match, np);
>> > iod->soc_data = match->data;
>> >
>> > + if (iod->soc_data->write)
>> > + iod->write = iod->soc_data->write;
>> > + else
>> > + iod->write = rockchip_iodomain_write;
>> > +
>> > parent = pdev->dev.parent;
>> > if (parent && parent->of_node) {
>> > iod->grf = syscon_node_to_regmap(parent->of_node);
>> > @@ -562,7 +634,7 @@ static int rockchip_iodomain_probe(struct platform_device *pdev)
>> > supply->reg = reg;
>> > supply->nb.notifier_call = rockchip_iodomain_notify;
>> >
>> > - ret = rockchip_iodomain_write(supply, uV);
>> > + ret = iod->write(supply, uV);
>> > if (ret) {
>> > supply->reg = NULL;
>> > goto unreg_notify;
>> >
>>
>
>
>
>
>
>
>
More information about the Linux-rockchip
mailing list