[PATCH v2 3/7] gpio: separate gpio driver from pinctrl-rockchip driver

[Heiko Stübner]

Hi Johan,

Am Sonntag, 11. April 2021, 19:51:52 CEST schrieb Johan Jonker:
> Hi,
> 
> When I check "rockchip,gpio-bank" with YAML it turns out that
> rk3288-veyron-XXX has 'gpio-line-names' as 'extra' property.
> It is not defined in the "rockchip,pinctrl.txt" document, but in
> ~/.local/lib/python3.5/site-packages/dtschema/schemas/gpio/gpio.yaml
> 
> Where is that in use?
> In this driver or external?
> Can it be removed from mainline dts?

gpio-line-names gets defined in devicetree/bindings/gpio/gpio.txt
which isn't converted to yaml yet:

Optionally, a GPIO controller may have a "gpio-line-names" property. This is
an array of strings defining the names of the GPIO lines going out of the
GPIO controller.


So that property is perfectly fine where it is.

Heiko


> 
> Johan
> 
> /arch/arm/boot/dts/rk3288-veyron-fievel.dt.yaml: gpio7 at ff7e0000:
> 'gpio-line-names' does not match any of the regexes: 'pinctrl-[0-9]+'
> 	From schema:
> /Documentation/devicetree/bindings/gpio/rockchip,gpio-bank.yaml
> 
> On 4/11/21 3:30 PM, Peter Geis wrote:
> > From: Jianqun Xu <jay.xu at rock-chips.com>
> > 
> > Separate the gpio driver from the pinctrl driver.
> > 
> > Signed-off-by: Jianqun Xu <jay.xu at rock-chips.com>
> > ---
>