[PATCH 4/8] arm64: dts: imx8mn: Correct interrupt flags in examples

Krzysztof Kozlowski krzk at kernel.org
Tue Sep 8 11:02:37 EDT 2020


GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning:
1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
2. GPIO_ACTIVE_LOW  = 1 = IRQ_TYPE_EDGE_RISING

Correct the interrupt flags, assuming the author of the code wanted some
logical behavior behind the name "ACTIVE_xxx", this is:
  ACTIVE_LOW  => IRQ_TYPE_LEVEL_LOW

Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>

---

Not tested on HW.
---
 arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts | 2 +-
 arch/arm64/boot/dts/freescale/imx8mn-evk.dts      | 3 ++-
 2 files changed, 3 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts b/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts
index a1e5483dbbbe..9e12b5234692 100644
--- a/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts
@@ -55,7 +55,7 @@
 		reg = <0x4b>;
 		pinctrl-0 = <&pinctrl_pmic>;
 		interrupt-parent = <&gpio1>;
-		interrupts = <3 GPIO_ACTIVE_LOW>;
+		interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
 		rohm,reset-snvs-powered;
 
 		regulators {
diff --git a/arch/arm64/boot/dts/freescale/imx8mn-evk.dts b/arch/arm64/boot/dts/freescale/imx8mn-evk.dts
index b846526a8d8b..707d8486b4d8 100644
--- a/arch/arm64/boot/dts/freescale/imx8mn-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mn-evk.dts
@@ -7,6 +7,7 @@
 
 #include "imx8mn.dtsi"
 #include "imx8mn-evk.dtsi"
+#include <dt-bindings/interrupt-controller/irq.h>
 
 / {
 	model = "NXP i.MX8MNano EVK board";
@@ -19,7 +20,7 @@
 		reg = <0x25>;
 		pinctrl-0 = <&pinctrl_pmic>;
 		interrupt-parent = <&gpio1>;
-		interrupts = <3 GPIO_ACTIVE_LOW>;
+		interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
 
 		regulators {
 			buck1: BUCK1{
-- 
2.17.1




More information about the Linux-rockchip mailing list