[PATCH v2 1/2] ARM: dts: rk3188: correct interrupt flags

[Krzysztof Kozlowski]

On Thu, Sep 17, 2020 at 08:52:10PM +0200, Krzysztof Kozlowski wrote:
> GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
> These are simple defines so they could be used in DTS but they will not
> have the same meaning:
> 1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
> 2. GPIO_ACTIVE_LOW  = 1 = IRQ_TYPE_EDGE_RISING
> 
> Correct the interrupt flags without affecting the code:
>   ACTIVE_HIGH => IRQ_TYPE_NONE
> 
> Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>
> 
> ---
> 
> Not tested on HW.
> 
> Changes since v1:
> 1. Correct title
> ---
>  arch/arm/boot/dts/rk3188-bqedison2qc.dts | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)

Hi,

Any comments/review/testing from Heiko or other Rockchip folks? Shall I
cc here someone?

Best regards,
Krzysztof