[PATCH 10/16] configs: Enable USB 2.0 on Rock-PI-N8

[Jagan Teki]

From: Suniel Mahesh <sunil at amarulasolutions.com>

Enable USB 2.0 and related configs for the Rock-PI-N8 target,
which hosts RK3288-VMARC-SOM.

Log:
Bus usb at ff500000: USB EHCI 1.00
Bus usb at ff540000: USB DWC2
Bus usb at ff580000: USB DWC2
scanning bus usb at ff500000 for devices... 2 USB Device(s) found
scanning bus usb at ff540000 for devices... 1 USB Device(s) found
scanning bus usb at ff580000 for devices... 1 USB Device(s) found
        scanning usb for storage devices... 1 Storage Device(s) found
=> usb tree
USB device tree:
1  Hub (480 Mb/s, 0mA)
|  u-boot EHCI Host Controller
|
+-2  Mass Storage (480 Mb/s, 224mA)
        SanDisk Dual Drive 04019c9b2e1a58f24ee318c3c123aa5

1  Hub (480 Mb/s, 0mA)
   U-Boot Root Hub

1  Hub (480 Mb/s, 0mA)
   U-Boot Root Hub

Signed-off-by: Suniel Mahesh <sunil at amarulasolutions.com>
Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>
---
 configs/rock-pi-n8-rk3288_defconfig | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/configs/rock-pi-n8-rk3288_defconfig b/configs/rock-pi-n8-rk3288_defconfig
index 6b31e19eda..4cbb07d870 100644
--- a/configs/rock-pi-n8-rk3288_defconfig
+++ b/configs/rock-pi-n8-rk3288_defconfig
@@ -22,6 +22,7 @@ CONFIG_CMD_GPIO=y
 CONFIG_CMD_GPT=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_MMC=y
+CONFIG_CMD_USB=y
 # CONFIG_CMD_SETEXPR is not set
 CONFIG_CMD_CACHE=y
 CONFIG_CMD_TIME=y
@@ -63,4 +64,11 @@ CONFIG_RAM=y
 CONFIG_SPL_RAM=y
 CONFIG_DEBUG_UART_SHIFT=2
 CONFIG_SYSRESET=y
+CONFIG_USB=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_EHCI_GENERIC=y
+CONFIG_USB_DWC2=y
+CONFIG_ROCKCHIP_USB2_PHY=y
+CONFIG_USB_KEYBOARD=y
+# CONFIG_USB_KEYBOARD_FN_KEYS is not set
 CONFIG_ERRNO_STR=y
-- 
2.25.1