[PATCH] drm: dw_hdmi: Gate audio sampler clock from the enablement functions

Neil Armstrong narmstrong at baylibre.com
Mon Mar 13 02:27:08 PDT 2017


On 03/10/2017 10:35 AM, Romain Perier wrote:
> Currently, the audio sampler clock is enabled from dw_hdmi_setup() at
> step E. and is kept enabled for later use. This clock should be enabled
> and disabled along with the actual audio stream and not always on (that
> is bad for PM). Futhermore, this might cause sound glitches with some
> HDMI devices, as the CTS+N is forced to zero when the stream is disabled
> while the audio clock is still running.
> 
> This commit adds a parameter to hdmi_audio_enable_clk() that controls
> when the audio sample clock must be enabled or disabled. Then, it moves
> the call to this function into dw_hdmi_audio_enable() and
> dw_hdmi_audio_disable().
> 
> Signed-off-by: Romain Perier <romain.perier at collabora.com>
> ---
>  drivers/gpu/drm/bridge/dw-hdmi.c | 15 +++++++++------
>  1 file changed, 9 insertions(+), 6 deletions(-)
> 

Hi Romain, Russell, Jose,

This is a little out of scope, but I was wondering why the CTS calculation was not left
in AUTO mode in the dw-hdmi driver ?

In the Amlogic Vendor tree, they don't set the HDMI_AUD_CTS3_CTS_MANUAL bit and leave
the CTS value to 0.

I am wondering if the AUTO feature is specific to newer IP version, or it was disabled
in the iMX.6 IP configuration ? or simply tied to the AHB audio specificity.

It would be simpler and smarter to leave the AUTO feature enabled for I2S and S/PDIF
input when the IP supports it.

Jose, is there a config bit for this feature, or a specific IP version where it landed ?

Anyway, we should really differentiate the AHB audio and I2S/SPDIF audio in the CTS/N calculation,
since the I2S/SPDIF depends on an different clock for audio input and the AUTO CTS calculation
feature will certainly offer a better clock synchronization.

Thanks,
Neil



More information about the Linux-rockchip mailing list