[PATCH v2 2/4] phy: rockchip-emmc: configure frequency range and drive impedance

Doug Anderson dianders at chromium.org
Fri May 13 15:04:53 PDT 2016


Hi,

On Fri, May 13, 2016 at 2:09 PM, Brian Norris <briannorris at chromium.org> wrote:
> From: Shawn Lin <shawn.lin at rock-chips.com>
>
> Signal integrity analysis has suggested we set these values. Do this in
> power_on(), so that they get reconfigured after suspend/resume.
>
> Signed-off-by: Shawn Lin <shawn.lin at rock-chips.com>
> Signed-off-by: Brian Norris <briannorris at chromium.org>
> ---
> v2:
>  * Sent only patch 2/4 with version 2, to avoid spamming; will move on to v3
>    for all patches if I need to send another
>  * Drop 170 MHz comment; this was only applicable to a subtly different Arasan
>    PHY
>
>  drivers/phy/phy-rockchip-emmc.c | 27 +++++++++++++++++++++++++++
>  1 file changed, 27 insertions(+)

As per my comments on v1, this is a sane starting point and seems like
a good idea to land.  Hopefully someone at Rockchip can pick things up
and continue making this more configurable.

Reviewed-by: Douglas Anderson <dianders at chromium.org>



More information about the Linux-rockchip mailing list