[PATCH 2/2] dt-bindings: rockchip-dw-mshc: add rockchip, default-drv-phase

[Doug Anderson]

Hi,

On Tue, May 10, 2016 at 7:50 PM, Shawn Lin <shawn.lin at rock-chips.com> wrote:
>>> maybe. But I think 180(downside) is the better.
>
>
> NAK my previous comments here. Downside is better for SRD, but won't
> work for DDR mode. When running in DDR mode, we should use 90 instead.
>
> So let me elaborate a bit more here.
> For DDR mode, one single clk cycle should sending two data bits outside
> to the devices. We need a hold time for both. If 180 is used, the first
> bit occurs around the downside area, which won't be sampled by devices
> on the upside.  So on the upside, the devices will see a zero bit if you
> actually send a one-bit, which makes the devices  generate CRC finally.
>
>
> For this above, 180 for all SDR mode is ok, but 90 should be deployed
> for DDR mode. So simply checking the timing to hardcode it should be
> fine.

OK, I sent out a patch for 180 always.  I can send v2 to use 90 for
DDR modes tomorrow.  ...or feel free to post that yourself if you
want.

We want 90 for all DDR modes?  So MMC_TIMING_UHS_DDR50,
MMC_TIMING_MMC_DDR52, MMC_TIMING_MMC_HS400? (not that we support HS400
in dw_mmc on Rockchip).

-Doug