[PATCH] brcmfmac: sdio: Increase the default timeouts a bit

[Julian Calaby]

Hi Arend,

On Tue, Jan 26, 2016 at 2:39 AM, Arend van Spriel <aspriel at gmail.com> wrote:
> On 25-01-16 12:06, Julian Calaby wrote:
>> Hi Sjoerd,
>>
>> On Mon, Jan 25, 2016 at 9:47 PM, Sjoerd Simons
>> <sjoerd.simons at collabora.co.uk> wrote:
>>> On a Radxa Rock2 board with a Ampak AP6335 (Broadcom 4339 core) it seems
>>> the card responds very quickly most of the time, unfortunately during
>>> initialisation it sometimes seems to take just a bit over 2 seconds to
>>> respond.
>>>
>>> This results intialization failing with message like:
>>>   brcmf_c_preinit_dcmds: Retreiving cur_etheraddr failed, -52
>>>   brcmf_bus_start: failed: -52
>>>   brcmf_sdio_firmware_callback: dongle is not responding
>>>
>>> Increasing the timeout to allow for a bit more headroom allows the
>>> card to initialize reliably.
>>>
>>> A quick search online after diagnosing/fixing this showed that Google
>>> has a similar patch in their ChromeOS tree, so this doesn't seem
>>> specific to the board I'm using.
>>>
>>> Signed-off-by: Sjoerd Simons <sjoerd.simons at collabora.co.uk>
>>
>> Looks sane to me.
>>
>> Reviewed-by: Julian Calaby <julian.calaby at gmail.com>
>
> Not really a cleanup patch :-p , but thanks for the review.

I'm trying to review any "small" patch from (relatively) new people.

Thanks,

-- 
Julian Calaby

Email: julian.calaby at gmail.com
Profile: http://www.google.com/profiles/julian.calaby/