[PATCH v5 1/5] riscv: dts: spacemit: k3: move USB3 phy to board level

[Aurelien Jarno]

On the SpacemiT K3 SoC, the combo phy provides 8 lines that can
either be used for PCIe or USB3, depending on its configuration
(spacemit,apmu). This configuration is defined at the board level, and
assigning a phy line to a USB3 controller while it is configured as PCIe
results in an "Invalid PHY mode" error.

Move the USB phy definitions at the board level, as it is done for the
submitted PCIe controller [1]. As a consequence, boards that do not
enable a USB3 controller node will not match the DT schema due to
missing PHY entries. This is not an issue as dtbs_check only validates
enabled nodes.

[1] https://lore.kernel.org/spacemit/20260923015016.64069-1-inochiama@gmail.com

Fixes: 46380e4b1534 ("riscv: dts: spacemit: k3: add USB controller and USB phy support")
Cc: Inochi Amaoto <inochiama at gmail.com>
Signed-off-by: Aurelien Jarno <aurelien at aurel32.net>
---
 arch/riscv/boot/dts/spacemit/k3-pico-itx.dts | 2 ++
 arch/riscv/boot/dts/spacemit/k3.dtsi         | 3 ---
 2 files changed, 2 insertions(+), 3 deletions(-)

diff --git a/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts b/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
index b084a35aa00e3..0a6f669d509a9 100644
--- a/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
+++ b/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
@@ -328,5 +328,7 @@ &usb3d_u2phy {
 };
 
 &usb3d {
+	phys = <&usb3d_u2phy>, <&combophy 4 PHY_TYPE_USB3>;
+	phy-names = "usb2-phy", "usb3-phy";
 	status = "okay";
 };
diff --git a/arch/riscv/boot/dts/spacemit/k3.dtsi b/arch/riscv/boot/dts/spacemit/k3.dtsi
index b9977e78e096a..1af47b7f1c8af 100644
--- a/arch/riscv/boot/dts/spacemit/k3.dtsi
+++ b/arch/riscv/boot/dts/spacemit/k3.dtsi
@@ -452,9 +452,6 @@ usb3d: usb at 81a00000 {
 				 <&syscon_apmu RESET_APMU_USB3_D_VCC>,
 				 <&syscon_apmu RESET_APMU_USB3_D_PHY>;
 			reset-names = "ahb", "vcc", "phy";
-			phys = <&usb3d_u2phy>,
-			       <&combophy 4 PHY_TYPE_USB3>;
-			phy-names = "usb2-phy", "usb3-phy";
 			phy_type = "utmi";
 			snps,dis_enblslpm_quirk;
 			snps,dis_u2_susphy_quirk;
-- 
2.53.0