[PATCH v2 4/4] riscv: dts: spacemit: Enable USB3.0/PCIe on OrangePi RV2

[Yixun Lan]

Hi Chukun, Han

I've merely checked the schematics..

On 16:00 Sat 14 Mar     , Chukun Pan wrote:
> Hi,
> 
> > +	regulator-usb3-vbus-5v {
> > +		compatible = "regulator-fixed";
> > +		regulator-name = "USB30_VBUS";
> > +		regulator-min-microvolt = <5000000>;
> > +		regulator-max-microvolt = <5000000>;
> > +		gpio = <&gpio K1_GPIO(97) GPIO_ACTIVE_HIGH>;
> 
> Is this true?
GPIO97 should be DVL1 which labeled as CAMERA1_RST..

> 
> > +		enable-active-high;
> > +	};
> > +
> > +	usb3_hub_5v: regulator-usb3-hub-5v {
> > +		compatible = "regulator-fixed";
> > +		regulator-name = "USB30_HUB";
> > +		regulator-min-microvolt = <5000000>;
> > +		regulator-max-microvolt = <5000000>;
> > +		gpio = <&gpio K1_GPIO(123) GPIO_ACTIVE_HIGH>;
> 
> Although GPIO123 is labeled as USB_HUB_EN, it actually
> supplies for USB3 vbus.
> 
I agree

> > +		enable-active-high;
> > +	};
> 
> > ...
> > +		peer-hub = <&hub_3_0>;
> > +		reset-gpios = <&gpio K1_GPIO(124) GPIO_ACTIVE_LOW>;
> 
> Really? GPIO124 is floating.
> 
Right, GPIO123 doesn't connect to any device
check the reset pin of GL3523, it connect to VCC_5V0 which is pulled high
unconditionally..

> > +	};
> 
> I still insist that the regulator name of DT should be the same
> as on the schematic. This will force us to review the schematic.
> 
> Thanks,
> Chukun
Also, it seems the VCC5V0_USB20 is missing too, which controlled by
pin USB0_OTG_EN -> GPIO126

-- 
Yixun Lan (dlan)