[PATCH 4/6] riscv: dts: spacemit: enable QSPI and add SPI NOR on Milk-V Jupiter

[Yao Zi]

On Tue, Mar 24, 2026 at 05:02:20PM +0800, Yixun Lan wrote:
> Hi Aurelien,
> 
> On 21:28 Sun 22 Mar     , Aurelien Jarno wrote:
> > Add the QSPI controller node for the Milk-V Jupiter board and describe
> > the attached SPI NOR flash (GD25Q64E).
> > 
> > The flash supports a frequency up to 133MHz (80 MHz for reads), and the
> > SoC supports a frequency up to 104 MHz. However tests have shown that
> > the flash is not reliably detected above 26.5 MHz, consistent with
> > frequency used in the vendor kernel. Therefore, use this frequency.
> > 
> ..
> > The m25p,fast-read properties is taken from the vendor kernel.
> > 
> So long as this is verified and works fine on board?
> 
> > Add a corresponding flash partition layout, matching the layout and the
> > names used in the vendor U-Boot.
> > 
> ..
> > Also add the bootph-pre-ram property to make the device tree usable by
> > early firmware/bootloaders without modification, as U-Boot is stored on
> > this NOR flash.
> Is the dtb file actually used by U-Boot? I'd highly doubt about this,
> if not the case or has not been tested, I'd suggest then not to add
> this property..

Currently no, but it would be a bogus if we could do it at introduction
of the device, if it's really necessary in pre-DRAM stages of
bootloaders, e.g. U-Boot SPL. This would reduce the duplicated work of
downstream projects if they decide to switch to Linux upstream
devicetree.

As SpacemiT K1 supports booting from flash, the description of flash
nodes are likely useful for pre-DRAM bootloaders.

> > 
> > Signed-off-by: Aurelien Jarno <aurelien at aurel32.net>

Best regards,
Yao Zi