[RFC PATCH 0/6] riscv: support EIC770X/JH7110 noncoherent devices with XPbmtUC

[Bo Gan]

Hi

On 3/13/26 05:30, Conor Dooley wrote:
> On Fri, Mar 13, 2026 at 01:44:01AM -0700, Bo Gan wrote:
>> Starfive JH7110 and ESWIN EIC770X both have non cache-coherent
>> peripherals. On JH7110[1], GPU/VOUT/VPU/ISP are routed to the sys port,
>> making them not cache-coherent. On EIC770X, all peripherals are routed
>> to the sys port, and none is cache-coherent. To make drivers work on
>> such platforms, the standard solution is to use Svpbmt and map the DMA
>> buffer as uncacheable. However, neither SoC supports Svpbmt. Instead,
>> they map the system memory twice, as cached and uncached. The uncached
>> alias implicitly applies the uncacheable PMA. To support such platform,
>> a special form of Svpbmt, namely "XPbmtUC" is introduced in this patch.
>> It's a synthetical PTE format where a single bit (UC) is controlling
>> the cacheability and the bit position can be configured at runtime. It
>> is intended to model the physical memory aliasing with minimal effort.
>>
>> On JH7110, it aligns perfectly with the HW, as the aliased UC region
>> happens to be offsetted by 2^34. Thus, configuring the XPbmtUC with
>> bit=32 (PPN is shifted by 2) is all that needs to be done.
>>
>> On EIC770X, the aliased UC region is put to a awkward offset, and given
>> there can be 2 NUMA node (dual-die) with 2 separate memory regions and
>> their UC alias counterpart, we instead ask the firmware to provide a
>> thin-layer hypervisor to re-arrange the memory map. The XPbmtUC will be
>> enabled with bit=38, thus map all UC pages to 2^40 (the upper-half of
>> 2^41), and the underlaying hypervisor will re-map the 2^40+ addresses
>> to the appropriate UC alias regions. (See description in PATCH 1/6)
>>
>> We chose bit 38 (PPN bit 40) to make the 2-stage translation efficient.
>> Hypervisor can utilize Sv39x4 G-stage scheme, and map all pages as 1GB
>> huge page, consuming only the first-level page table (16KB total), and
>> several TLB entries. In practice, it's the firmware/bootloader that
>> configures XPbmtUC through device-tree, based on firmware capabilities,
>> and skip the enablement on stock firmware. This is tested on Hifive
>> Premier P550 with the modified OpenSBI[2]. It runs the host Linux in VS
>> mode, and provide the aforementioned remapping. The performance penalty
>> (if not running KVM in Linux) is minimal, as the CPU is never switched
>> to HS mode. A very slight, unavoidable, slow down is with the external
>> interrupt delivery. Due to the lack of AIA in EIC770X, all device irq
>> now needs to trap to M mode first, before forwarding to VS mode. The
>> overhead of running KVM in such setup is yet unknown, and may well be
>> noticeable, as all HS-qualified instructions will trap to M mode, and
>> there's also the extra cost of flushing G/VS-stage TLBs. I'm analyzing
>> it in parallel.
>>
>> I'm aware there's an ongoing series that Samuel sent for physical
>> memory aliases. I haven't been following too closely, but if you're
>> worried about it touching to many areas, I hope my series can shed some
>> light on the problem. My change is very minimal and local, also fairly
>> easy to remove if we later decide deprecating it down the road.
>>
>> [1] https://github.com/starfive-tech/JH7100_Docs/blob/main/JH7100%20Cache%20Coherence%20V1.0.pdf
>> [2] https://github.com/ganboing/opensbi/tree/eic77x-vspt-physalias-wip
> 
> For those following along at home, Samuel's series is:
> https://lore.kernel.org/all/20251113014656.2605447-20-samuel.holland@sifive.com/
> 
> I've been meaning to try it, but never conjured up the time to dig into
> it...

Thanks, Conor. I don't mean to step ahead of Samuel, just want to find a
middle ground that's easier to maintain from kernel perspective. I know
riscv HW is evolving rapidly, and we just don't want to add way too many
workarounds for each SoC. Hence I decided to move the re-mapping logic to
firmware/hypervisor to keep the kernel clean. If you'd like, use my v6.19
tree for testing on Hifive P550 if you have one:
https://github.com/ganboing/linux-eic77/tree/ganboing-xpbmt-uc-v1-eic77-clk-v15
I'm also sanity checking on my JH7110.

Bo