[PATCH net-next v7 0/7] net: stmmac: qcom-ethqos: add support for SCMI power domains

[Bartosz Golaszewski]

On Tue, Mar 10, 2026 at 2:10 AM Radu Rendec <rrendec at redhat.com> wrote:
>
> On Fri, 2026-03-06 at 16:46 +0100, Bartosz Golaszewski wrote:
> > Add support for the firmware-managed variant of the DesignWare MAC on
> > the sa8255p platform. This series contains new DT bindings and driver
> > changes required to support the MAC in the STMMAC driver.
> >
> > It also reorganizes the ethqos code quite a bit to make the introduction
> > of power domains into the driver a bit easier on the eye.
> >
> > The DTS changes will go in separately.
>
> As Jakub pointed out, it conflicts with the latest net-next, but does
> apply cleanly on the latest mainline, so I tested there (on a SA8775P
> board running the SCMI firmware).
>
> The two NICs come up as expected. Basic iperf3 throughput and jitter
> tests look good. I would offer a Tested-by tag and a summary of the
> test results, but I think it's a moot point because you'll have to
> submit a new version anyway.
>
> I will wait for you to rebase, then test again and come back with the
> results.
>

Thank you for the tests. The rework after the changes turned out to be
quite extensive. I should have it ready by the end of the week. I will
appreciate if you could retest it again by then and leave your tag.

Bart