[PATCH net-next v12 4/5] riscv: dts: spacemit: Add Ethernet support for BPI-F3

[Andrew Lunn]

On Sun, Sep 14, 2025 at 12:31:04PM +0800, Vivian Wang wrote:
> On 9/14/25 12:23, Vivian Wang wrote:
> > Banana Pi BPI-F3 uses an RGMII PHY for each port and uses GPIO for PHY
> > reset.
> >
> > Tested-by: Hendrik Hamerlinck <hendrik.hamerlinck at hammernet.be>
> > Signed-off-by: Vivian Wang <wangruikang at iscas.ac.cn>
> > Reviewed-by: Yixun Lan <dlan at gentoo.org>
> > Reviewed-by: Andrew Lunn <andrew at lunn.ch>
> > ---
> >  arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts | 48 +++++++++++++++++++++++++
> >  1 file changed, 48 insertions(+)
> >
> > diff --git a/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts b/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts
> > index fe22c747c5012fe56d42ac8a7efdbbdb694f31b6..33e223cefd4bd3a12fae176ac6cddd8276cb53dc 100644
> > --- a/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts
> > +++ b/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts
> > @@ -11,6 +11,8 @@ / {
> >  	compatible = "bananapi,bpi-f3", "spacemit,k1";
> >  
> >  	aliases {
> > +		ethernet0 = &eth0;
> > +		ethernet1 = &eth1;
> 
> Hi Andrew,
> 
> I added these two aliases in v12, but kept your Reviewed-by for v11
> because this is fairly trivial. Same for patch 5.
> 
> Is this okay?

Yes, this is fine.

	Andrew