[PATCH net-next v3 3/5] riscv: dts: spacemit: Add Ethernet support for K1

[Vivian Wang]

Add nodes for each of the two Ethernet MACs on K1 with generic
properties. Also add "gmac" pins to pinctrl config.

Signed-off-by: Vivian Wang <wangruikang at iscas.ac.cn>
---
 arch/riscv/boot/dts/spacemit/k1-pinctrl.dtsi | 48 ++++++++++++++++++++++++++++
 arch/riscv/boot/dts/spacemit/k1.dtsi         | 22 +++++++++++++
 2 files changed, 70 insertions(+)

diff --git a/arch/riscv/boot/dts/spacemit/k1-pinctrl.dtsi b/arch/riscv/boot/dts/spacemit/k1-pinctrl.dtsi
index 283663647a86ff137917ced8bfe79a129c86342a..37f3deeaffb987756581a956d634eeb81ac20b1f 100644
--- a/arch/riscv/boot/dts/spacemit/k1-pinctrl.dtsi
+++ b/arch/riscv/boot/dts/spacemit/k1-pinctrl.dtsi
@@ -11,6 +11,54 @@
 #define K1_GPIO(x)	(x / 32) (x % 32)
 
 &pinctrl {
+	gmac0_cfg: gmac0-cfg {
+		gmac0-pins {
+			pinmux = <K1_PADCONF(0, 1)>,	/* gmac0_rxdv */
+				 <K1_PADCONF(1, 1)>,	/* gmac0_rx_d0 */
+				 <K1_PADCONF(2, 1)>,	/* gmac0_rx_d1 */
+				 <K1_PADCONF(3, 1)>,	/* gmac0_rx_clk */
+				 <K1_PADCONF(4, 1)>,	/* gmac0_rx_d2 */
+				 <K1_PADCONF(5, 1)>,	/* gmac0_rx_d3 */
+				 <K1_PADCONF(6, 1)>,	/* gmac0_tx_d0 */
+				 <K1_PADCONF(7, 1)>,	/* gmac0_tx_d1 */
+				 <K1_PADCONF(8, 1)>,	/* gmac0_tx */
+				 <K1_PADCONF(9, 1)>,	/* gmac0_tx_d2 */
+				 <K1_PADCONF(10, 1)>,	/* gmac0_tx_d3 */
+				 <K1_PADCONF(11, 1)>,	/* gmac0_tx_en */
+				 <K1_PADCONF(12, 1)>,	/* gmac0_mdc */
+				 <K1_PADCONF(13, 1)>,	/* gmac0_mdio */
+				 <K1_PADCONF(14, 1)>,	/* gmac0_int_n */
+				 <K1_PADCONF(45, 1)>;	/* gmac0_clk_ref */
+
+			bias-pull-up = <0>;
+			drive-strength = <21>;
+		};
+	};
+
+	gmac1_cfg: gmac1-cfg {
+		gmac1-pins {
+			pinmux = <K1_PADCONF(29, 1)>,	/* gmac1_rxdv */
+				 <K1_PADCONF(30, 1)>,	/* gmac1_rx_d0 */
+				 <K1_PADCONF(31, 1)>,	/* gmac1_rx_d1 */
+				 <K1_PADCONF(32, 1)>,	/* gmac1_rx_clk */
+				 <K1_PADCONF(33, 1)>,	/* gmac1_rx_d2 */
+				 <K1_PADCONF(34, 1)>,	/* gmac1_rx_d3 */
+				 <K1_PADCONF(35, 1)>,	/* gmac1_tx_d0 */
+				 <K1_PADCONF(36, 1)>,	/* gmac1_tx_d1 */
+				 <K1_PADCONF(37, 1)>,	/* gmac1_tx */
+				 <K1_PADCONF(38, 1)>,	/* gmac1_tx_d2 */
+				 <K1_PADCONF(39, 1)>,	/* gmac1_tx_d3 */
+				 <K1_PADCONF(40, 1)>,	/* gmac1_tx_en */
+				 <K1_PADCONF(41, 1)>,	/* gmac1_mdc */
+				 <K1_PADCONF(42, 1)>,	/* gmac1_mdio */
+				 <K1_PADCONF(43, 1)>,	/* gmac1_int_n */
+				 <K1_PADCONF(46, 1)>;	/* gmac1_clk_ref */
+
+			bias-pull-up = <0>;
+			drive-strength = <21>;
+		};
+	};
+
 	uart0_2_cfg: uart0-2-cfg {
 		uart0-2-pins {
 			pinmux = <K1_PADCONF(68, 2)>,
diff --git a/arch/riscv/boot/dts/spacemit/k1.dtsi b/arch/riscv/boot/dts/spacemit/k1.dtsi
index 937b87c563a6b1e97740286c723aca52207f3f48..ce9cd8854bec8dbe48517b4ce57cee69d4d1d2f5 100644
--- a/arch/riscv/boot/dts/spacemit/k1.dtsi
+++ b/arch/riscv/boot/dts/spacemit/k1.dtsi
@@ -625,6 +625,28 @@ network-bus {
 			#size-cells = <2>;
 			dma-ranges = <0x0 0x00000000 0x0 0x00000000 0x0 0x80000000>,
 				     <0x0 0x80000000 0x1 0x00000000 0x0 0x80000000>;
+
+			eth0: ethernet at cac80000 {
+				compatible = "spacemit,k1-emac";
+				reg = <0x0 0xcac80000 0x0 0x420>;
+				clocks = <&syscon_apmu CLK_EMAC0_BUS>;
+				interrupts = <131>;
+				mac-address = [ 00 00 00 00 00 00 ];
+				resets = <&syscon_apmu RESET_EMAC0>;
+				spacemit,apmu = <&syscon_apmu 0x3e4>;
+				status = "disabled";
+			};
+
+			eth1: ethernet at cac81000 {
+				compatible = "spacemit,k1-emac";
+				reg = <0x0 0xcac81000 0x0 0x420>;
+				clocks = <&syscon_apmu CLK_EMAC1_BUS>;
+				interrupts = <133>;
+				mac-address = [ 00 00 00 00 00 00 ];
+				resets = <&syscon_apmu RESET_EMAC1>;
+				spacemit,apmu = <&syscon_apmu 0x3ec>;
+				status = "disabled";
+			};
 		};
 
 		pcie-bus {

-- 
2.49.0