[PATCH 7/7] riscv: dts: starfive: Add initial StarFive JH8100 device tree

[Krzysztof Kozlowski]

On 27/11/2023 10:20, Conor Dooley wrote:
> On Mon, Nov 27, 2023 at 09:50:35AM +0100, Krzysztof Kozlowski wrote:
>> On 27/11/2023 02:36, Sia Jee Heng wrote:
> 
>>> +	chosen {
>>> +		stdout-path = "serial0:115200n8";
>>> +	};
>>> +
>>> +	cpus {
>>> +		timebase-frequency = <4000000>;
>>
>> This was fixed recently on the mailing lists.
> 
> Actually, I only fixed this for the microchip stuff, as I don't know
> whether or not having this in $board.dts is valid for other cases.
> 
> As far as I understand it, this works just like regular clock nodes, so
> if the clock is provided by an off-chip crystal it is okay to have it in
> $board.dts, but otherwise it should go in $soc.dts.
> 
> The same applies to the jh7100/jh7110, so if you could clarify it for
> that platform too, that'd be great. Doing it in response to
> https://lore.kernel.org/all/20231126-attractor-swampland-b1b95bd1322b@spud/
> would be great.

OK, then it should be added via label syntax, not by full node path.

Best regards,
Krzysztof