[PATCH v3 07/11] irqchip/riscv-imsic: Improve IOMMU DMA support

[Jason Gunthorpe]

On Mon, May 08, 2023 at 07:58:38PM +0530, Anup Patel wrote:
> We have a separate RISC-V IMSIC MSI address for each CPU so changing
> MSI (or IRQ) affinity results in re-programming of MSI address in
> the PCIe (or platform) device.
> 
> Currently, the iommu_dma_prepare_msi() is called only once at the
> time of IRQ allocation so IOMMU DMA domain will only have mapping
> for one MSI page. This means iommu_dma_compose_msi_msg() called
> by imsic_irq_compose_msi_msg() will always use the same MSI page
> irrespective to target CPU MSI address. In other words, changing
> MSI (or IRQ) affinity for device using IOMMU DMA domain will not
> work.
> 
> To address above issue, we do the following:
> 1) Map MSI pages for all CPUs in imsic_irq_domain_alloc()
>    using iommu_dma_prepare_msi().
> 2) Add a new iommu_dma_select_msi() API to select a specific
>    MSI page from a set of already mapped MSI pages.
> 3) Use iommu_dma_select_msi() to select a specific MSI page
>    before calling iommu_dma_compose_msi_msg() in
>    imsic_irq_compose_msi_msg().

Is there an iommu driver somewhere in all this? I don't obviously see
one?

There should be no reason to use the dma-iommu.c stuff just to make
interrupts work, that is only necessary if there is an iommu, and the
platform architecture requires the iommu to have the MSI region
programmed into IOPTEs.

And I'd be much happier if we could clean this design up before risc-v
starts using it too :\

Jason