[patch v3 13/36] x86/smpboot: Remove cpu_callin_mask

[Thomas Gleixner]

From: Thomas Gleixner <tglx at linutronix.de>

Now that TSC synchronization is SMP function call based there is no reason
to wait for the AP to be set in smp_callin_mask. The control CPU waits for
the AP to set itself in the online mask anyway.

Signed-off-by: Thomas Gleixner <tglx at linutronix.de>
Tested-by: Michael Kelley <mikelley at microsoft.com>


---
 arch/x86/kernel/smpboot.c |   61 +++++++---------------------------------------
 1 file changed, 10 insertions(+), 51 deletions(-)
---

--- a/arch/x86/kernel/smpboot.c
+++ b/arch/x86/kernel/smpboot.c
@@ -104,7 +104,6 @@ EXPORT_PER_CPU_SYMBOL(cpu_info);
 /* All of these masks are initialized in setup_cpu_local_masks() */
 static cpumask_var_t cpu_initialized_mask;
 static cpumask_var_t cpu_callout_mask;
-static cpumask_var_t cpu_callin_mask;
 /* Representing CPUs for which sibling maps can be computed */
 static cpumask_var_t cpu_sibling_setup_mask;
 
@@ -167,21 +166,16 @@ static inline void smpboot_restore_warm_
  */
 static void smp_callin(void)
 {
-	int cpuid;
+	int cpuid = smp_processor_id();
 
 	/*
 	 * If waken up by an INIT in an 82489DX configuration
-	 * cpu_callout_mask guarantees we don't get here before
-	 * an INIT_deassert IPI reaches our local APIC, so it is
-	 * now safe to touch our local APIC.
-	 */
-	cpuid = smp_processor_id();
-
-	/*
-	 * the boot CPU has finished the init stage and is spinning
-	 * on callin_map until we finish. We are free to set up this
-	 * CPU, first the APIC. (this is probably redundant on most
-	 * boards)
+	 * cpu_callout_mask guarantees we don't get here before an
+	 * INIT_deassert IPI reaches our local APIC, so it is now safe to
+	 * touch our local APIC.
+	 *
+	 * Set up this CPU, first the APIC, which is probably redundant on
+	 * most boards.
 	 */
 	apic_ap_setup();
 
@@ -192,7 +186,7 @@ static void smp_callin(void)
 	 * The topology information must be up to date before
 	 * calibrate_delay() and notify_cpu_starting().
 	 */
-	set_cpu_sibling_map(raw_smp_processor_id());
+	set_cpu_sibling_map(cpuid);
 
 	ap_init_aperfmperf();
 
@@ -205,11 +199,6 @@ static void smp_callin(void)
 	 * state (CPUHP_ONLINE in the case of serial bringup).
 	 */
 	notify_cpu_starting(cpuid);
-
-	/*
-	 * Allow the master to continue.
-	 */
-	cpumask_set_cpu(cpuid, cpu_callin_mask);
 }
 
 static void ap_calibrate_delay(void)
@@ -268,11 +257,6 @@ static void notrace start_secondary(void
 	rcu_cpu_starting(raw_smp_processor_id());
 	x86_cpuinit.early_percpu_clock_init();
 
-	/*
-	 * Sync point with wait_cpu_callin(). The AP doesn't wait here
-	 * but just sets the bit to let the controlling CPU (BSP) know that
-	 * it's got this far.
-	 */
 	smp_callin();
 
 	/* Otherwise gcc will move up smp_processor_id() before cpu_init() */
@@ -1112,7 +1096,7 @@ static int wait_cpu_cpumask(unsigned int
  * and thus wait_for_master_cpu(), then set cpu_callout_mask to allow it
  * to proceed.  The AP will then proceed past setting its 'callin' bit
  * and end up waiting in check_tsc_sync_target() until we reach
- * do_wait_cpu_online() to tend to it.
+ * wait_cpu_online() to tend to it.
  */
 static int wait_cpu_initialized(unsigned int cpu)
 {
@@ -1127,20 +1111,7 @@ static int wait_cpu_initialized(unsigned
 }
 
 /*
- * Bringup step three: Wait for the target AP to reach smp_callin().
- * The AP is not waiting for us here so we don't need to parallelise
- * this step. Not entirely clear why we care about this, since we just
- * proceed directly to TSC synchronization which is the next sync
- * point with the AP anyway.
- */
-static void wait_cpu_callin(unsigned int cpu)
-{
-	while (!cpumask_test_cpu(cpu, cpu_callin_mask))
-		schedule();
-}
-
-/*
- * Bringup step four: Wait for the target AP to reach set_cpu_online() in
+ * Bringup step three: Wait for the target AP to reach set_cpu_online() in
  * start_secondary().
  */
 static void wait_cpu_online(unsigned int cpu)
@@ -1170,14 +1141,6 @@ static int native_kick_ap(unsigned int c
 	}
 
 	/*
-	 * Already booted CPU?
-	 */
-	if (cpumask_test_cpu(cpu, cpu_callin_mask)) {
-		pr_debug("do_boot_cpu %d Already started\n", cpu);
-		return -ENOSYS;
-	}
-
-	/*
 	 * Save current MTRR state in case it was changed since early boot
 	 * (e.g. by the ACPI SMI) to initialize new CPUs with MTRRs in sync:
 	 */
@@ -1214,7 +1177,6 @@ int native_cpu_up(unsigned int cpu, stru
 	if (ret)
 		goto out;
 
-	wait_cpu_callin(cpu);
 	wait_cpu_online(cpu);
 
 out:
@@ -1330,7 +1292,6 @@ void __init smp_prepare_cpus_common(void
 	 * Setup boot CPU information
 	 */
 	smp_store_boot_cpu_info(); /* Final full version of the data */
-	cpumask_copy(cpu_callin_mask, cpumask_of(0));
 	mb();
 
 	for_each_possible_cpu(i) {
@@ -1545,7 +1506,6 @@ early_param("possible_cpus", _setup_poss
 void __init setup_cpu_local_masks(void)
 {
 	alloc_bootmem_cpumask_var(&cpu_initialized_mask);
-	alloc_bootmem_cpumask_var(&cpu_callin_mask);
 	alloc_bootmem_cpumask_var(&cpu_callout_mask);
 	alloc_bootmem_cpumask_var(&cpu_sibling_setup_mask);
 }
@@ -1609,7 +1569,6 @@ static void remove_cpu_from_maps(int cpu
 {
 	set_cpu_online(cpu, false);
 	cpumask_clear_cpu(cpu, cpu_callout_mask);
-	cpumask_clear_cpu(cpu, cpu_callin_mask);
 	/* was set by cpu_init() */
 	cpumask_clear_cpu(cpu, cpu_initialized_mask);
 	numa_remove_cpu(cpu);