[PATCH] riscv: dts: allwinner: d1: Specify default CAN pins

[John Watts]

There are only one set of CAN pins available on these chips.
Specify these as the default to avoid redundancy in board device trees.

Signed-off-by: John Watts <contact at jookia.org>
---
 arch/riscv/boot/dts/allwinner/sunxi-d1s-t113.dtsi | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/riscv/boot/dts/allwinner/sunxi-d1s-t113.dtsi b/arch/riscv/boot/dts/allwinner/sunxi-d1s-t113.dtsi
index 4086c0cc0f9d..b27c3fc13b0d 100644
--- a/arch/riscv/boot/dts/allwinner/sunxi-d1s-t113.dtsi
+++ b/arch/riscv/boot/dts/allwinner/sunxi-d1s-t113.dtsi
@@ -898,6 +898,8 @@ can0: can at 2504000 {
 			interrupts = <SOC_PERIPHERAL_IRQ(21) IRQ_TYPE_LEVEL_HIGH>;
 			clocks = <&ccu CLK_BUS_CAN0>;
 			resets = <&ccu RST_BUS_CAN0>;
+			pinctrl-names = "default";
+			pinctrl-0 = <&can0_pins>;
 			status = "disabled";
 		};
 
@@ -907,6 +909,8 @@ can1: can at 2504400 {
 			interrupts = <SOC_PERIPHERAL_IRQ(22) IRQ_TYPE_LEVEL_HIGH>;
 			clocks = <&ccu CLK_BUS_CAN1>;
 			resets = <&ccu RST_BUS_CAN1>;
+			pinctrl-names = "default";
+			pinctrl-0 = <&can1_pins>;
 			status = "disabled";
 		};
 	};
-- 
2.41.0