[PATCH v2 00/35] arm64/gcs: Provide support for GCS in userspace
Mark Brown
broonie at kernel.org
Mon Jul 24 05:45:47 PDT 2023
The arm64 Guarded Control Stack (GCS) feature provides support for
hardware protected stacks of return addresses, intended to provide
hardening against return oriented programming (ROP) attacks and to make
it easier to gather call stacks for applications such as profiling.
When GCS is active a secondary stack called the Guarded Control Stack is
maintained, protected with a memory attribute which means that it can
only be written with specific GCS operations. When a BL is executed the
value stored in LR is also pushed onto the GCS, and when a RET is
executed the top of the GCS is popped and compared to LR with a fault
being raised if the values do not match. GCS operations may only be
performed on GCS pages, a data abort is generated if they are not.
This series implements support for use of GCS by userspace, along with
support for use of GCS within KVM guests. It does not enable use of GCS
by either EL1 or EL2. Executables are started without GCS and must use
a prctl() to enable it, it is expected that this will be done very early
in application execution by the dynamic linker or other startup code.
x86 has an equivalent feature called shadow stacks, this series depends
on the x86 patches for generic memory management support for the new
guarded/shadow stack page type and shares APIs as much as possible. As
there has been extensive discussion with the wider community around the
ABI for shadow stacks I have as far as practical kept implementation
decisions close to those for x86, anticipating that review would lead to
similar conclusions in the absence of strong reasoning for divergence.
The main divergence I am concious of is that x86 allows shadow stack to
be enabled and disabled repeatedly, freeing the shadow stack for the
thread whenever disabled, while this implementation keeps the GCS
allocated after disable but refuses to reenable it. This is to avoid
races with things actively walking the GCS during a disable, we do
anticipate that some systems will wish to disable GCS at runtime but are
not aware of any demand for subsequently reenabling it.
x86 uses an arch_prctl() to manage enable and disable, since only x86
and S/390 use arch_prctl() a generic prctl() was proposed[1] as part of a
patch set for the equivalent RISC-V zisslpcfi feature which I initially
adopted fairly directly but following review feedback has been reviewed
quite a bit.
There is an open issue with support for CRIU, on x86 this required the
ability to set the GCS mode via ptrace. This series supports
configuring mode bits other than enable/disable via ptrace but it needs
to be confirmed if this is sufficient.
There's a few bits where I'm not convinced with where I've placed
things, in particular the GCS write operation is in the GCS header not
in uaccess.h, I wasn't sure what was clearest there and am probably too
close to the code to have a clear opinion. The reporting of GCS in
/proc/PID/smaps is also a bit awkward.
The series depends on the x86 shadow stack support:
https://lore.kernel.org/lkml/20230227222957.24501-1-rick.p.edgecombe@intel.com/
I've rebased this onto v6.5-rc3 but not included it in the series in
order to avoid confusion with Rick's work and cut down the size of the
series, you can see the branch at:
https://git.kernel.org/pub/scm/linux/kernel/git/broonie/misc.git arm64-gcs
[1] https://lore.kernel.org/lkml/20230213045351.3945824-1-debug@rivosinc.com/
Signed-off-by: Mark Brown <broonie at kernel.org>
---
Changes in v2:
- Rebase onto v6.5-rc3.
- Rework prctl() interface to allow each bit to be locked independently.
- map_shadow_stack() now places the cap token based on the size
requested by the caller not the actual space allocated.
- Mode changes other than enable via ptrace are now supported.
- Expand test coverage.
- Various smaller fixes and adjustments.
- Link to v1: https://lore.kernel.org/r/20230716-arm64-gcs-v1-0-bf567f93bba6@kernel.org
---
Mark Brown (35):
prctl: arch-agnostic prctl for shadow stack
arm64: Document boot requirements for Guarded Control Stacks
arm64/gcs: Document the ABI for Guarded Control Stacks
arm64/sysreg: Add new system registers for GCS
arm64/sysreg: Add definitions for architected GCS caps
arm64/gcs: Add manual encodings of GCS instructions
arm64/gcs: Provide copy_to_user_gcs()
arm64/cpufeature: Runtime detection of Guarded Control Stack (GCS)
arm64/mm: Allocate PIE slots for EL0 guarded control stack
mm: Define VM_SHADOW_STACK for arm64 when we support GCS
arm64/mm: Map pages for guarded control stack
KVM: arm64: Manage GCS registers for guests
arm64/el2_setup: Allow GCS usage at EL0 and EL1
arm64/idreg: Add overrride for GCS
arm64/hwcap: Add hwcap for GCS
arm64/traps: Handle GCS exceptions
arm64/mm: Handle GCS data aborts
arm64/gcs: Context switch GCS registers for EL0
arm64/gcs: Allocate a new GCS for threads with GCS enabled
arm64/gcs: Implement shadow stack prctl() interface
arm64/mm: Implement map_shadow_stack()
arm64/signal: Set up and restore the GCS context for signal handlers
arm64/signal: Expose GCS state in signal frames
arm64/ptrace: Expose GCS via ptrace and core files
arm64: Add Kconfig for Guarded Control Stack (GCS)
kselftest/arm64: Verify the GCS hwcap
kselftest/arm64: Add GCS as a detected feature in the signal tests
kselftest/arm64: Add framework support for GCS to signal handling tests
kselftest/arm64: Allow signals tests to specify an expected si_code
kselftest/arm64: Always run signals tests with GCS enabled
kselftest/arm64: Add very basic GCS test program
kselftest/arm64: Add a GCS test program built with the system libc
kselftest/arm64: Add test coverage for GCS mode locking
selftests/arm64: Add GCS signal tests
kselftest/arm64: Enable GCS for the FP stress tests
Documentation/admin-guide/kernel-parameters.txt | 3 +
Documentation/arch/arm64/booting.rst | 22 ++
Documentation/arch/arm64/elf_hwcaps.rst | 3 +
Documentation/arch/arm64/gcs.rst | 225 +++++++++++++
Documentation/arch/arm64/index.rst | 1 +
Documentation/filesystems/proc.rst | 2 +-
arch/arm64/Kconfig | 19 ++
arch/arm64/include/asm/cpufeature.h | 6 +
arch/arm64/include/asm/el2_setup.h | 17 +
arch/arm64/include/asm/esr.h | 28 +-
arch/arm64/include/asm/exception.h | 2 +
arch/arm64/include/asm/gcs.h | 106 ++++++
arch/arm64/include/asm/hwcap.h | 1 +
arch/arm64/include/asm/kvm_host.h | 12 +
arch/arm64/include/asm/pgtable-prot.h | 14 +-
arch/arm64/include/asm/processor.h | 7 +
arch/arm64/include/asm/sysreg.h | 20 ++
arch/arm64/include/asm/uaccess.h | 42 +++
arch/arm64/include/uapi/asm/hwcap.h | 1 +
arch/arm64/include/uapi/asm/ptrace.h | 8 +
arch/arm64/include/uapi/asm/sigcontext.h | 9 +
arch/arm64/kernel/cpufeature.c | 19 ++
arch/arm64/kernel/cpuinfo.c | 1 +
arch/arm64/kernel/entry-common.c | 23 ++
arch/arm64/kernel/idreg-override.c | 2 +
arch/arm64/kernel/process.c | 78 +++++
arch/arm64/kernel/ptrace.c | 59 ++++
arch/arm64/kernel/signal.c | 237 ++++++++++++-
arch/arm64/kernel/traps.c | 11 +
arch/arm64/kvm/hyp/include/hyp/sysreg-sr.h | 17 +
arch/arm64/kvm/sys_regs.c | 22 ++
arch/arm64/mm/Makefile | 1 +
arch/arm64/mm/fault.c | 78 ++++-
arch/arm64/mm/gcs.c | 226 +++++++++++++
arch/arm64/mm/mmap.c | 17 +-
arch/arm64/tools/cpucaps | 1 +
arch/arm64/tools/sysreg | 55 +++
fs/proc/task_mmu.c | 3 +
include/linux/mm.h | 16 +-
include/linux/syscalls.h | 1 +
include/uapi/asm-generic/unistd.h | 5 +-
include/uapi/linux/elf.h | 1 +
include/uapi/linux/prctl.h | 22 ++
kernel/sys.c | 30 ++
kernel/sys_ni.c | 1 +
tools/testing/selftests/arm64/Makefile | 2 +-
tools/testing/selftests/arm64/abi/hwcap.c | 19 ++
tools/testing/selftests/arm64/fp/assembler.h | 15 +
tools/testing/selftests/arm64/fp/fpsimd-test.S | 2 +
tools/testing/selftests/arm64/fp/sve-test.S | 2 +
tools/testing/selftests/arm64/fp/za-test.S | 2 +
tools/testing/selftests/arm64/fp/zt-test.S | 2 +
tools/testing/selftests/arm64/gcs/.gitignore | 3 +
tools/testing/selftests/arm64/gcs/Makefile | 19 ++
tools/testing/selftests/arm64/gcs/basic-gcs.c | 351 +++++++++++++++++++
tools/testing/selftests/arm64/gcs/gcs-locking.c | 200 +++++++++++
tools/testing/selftests/arm64/gcs/gcs-util.h | 87 +++++
tools/testing/selftests/arm64/gcs/libc-gcs.c | 372 +++++++++++++++++++++
tools/testing/selftests/arm64/signal/.gitignore | 1 +
.../testing/selftests/arm64/signal/test_signals.c | 17 +-
.../testing/selftests/arm64/signal/test_signals.h | 6 +
.../selftests/arm64/signal/test_signals_utils.c | 32 +-
.../selftests/arm64/signal/test_signals_utils.h | 39 +++
.../arm64/signal/testcases/gcs_exception_fault.c | 59 ++++
.../selftests/arm64/signal/testcases/gcs_frame.c | 78 +++++
.../arm64/signal/testcases/gcs_write_fault.c | 67 ++++
.../selftests/arm64/signal/testcases/testcases.c | 7 +
.../selftests/arm64/signal/testcases/testcases.h | 1 +
68 files changed, 2825 insertions(+), 32 deletions(-)
---
base-commit: b8f2cc1100d85456f9a48243328b33ab0ce5caff
change-id: 20230303-arm64-gcs-e311ab0d8729
Best regards,
--
Mark Brown <broonie at kernel.org>
More information about the linux-riscv
mailing list