[PATCH v1 0/2] Add ethernet nodes for StarFive JH7110 SoC

[Guo Samin]

-------- 原始信息 --------
主题: Re: [PATCH v1 0/2] Add ethernet nodes for StarFive JH7110 SoC
From: Conor Dooley <conor at kernel.org>
收件人: Conor Dooley <conor at kernel.org>, Rob Herring <robh+dt at kernel.org>, Krzysztof Kozlowski <krzysztof.kozlowski+dt at linaro.org>, Paul Walmsley <paul.walmsley at sifive.com>, Palmer Dabbelt <palmer at dabbelt.com>, Albert Ou <aou at eecs.berkeley.edu>, Hal Feng <hal.feng at starfivetech.com>, linux-kernel at vger.kernel.org, linux-riscv at lists.infradead.org, devicetree at vger.kernel.org, netdev at vger.kernel.org, Samin Guo <samin.guo at starfivetech.com>
日期: 2023/7/21

> From: Conor Dooley <conor.dooley at microchip.com>
> 
> On Fri, 14 Jul 2023 18:45:19 +0800, Samin Guo wrote:
>> This series adds ethernet nodes for StarFive JH7110 RISC-V SoC,
>> and has been tested on StarFive VisionFive-2 v1.2A and v1.3B SBC boards.
>>
>> The first patch adds ethernet nodes for jh7110 SoC, the second patch
>> adds ethernet nodes for visionfive 2 SBCs.
>>
>> This series relies on xingyu's syscon patch[1].
>> For more information and support, you can visit RVspace wiki[2].
>>
>> [...]
> 
> Applied to riscv-dt-for-next, thanks!
> 
> [1/2] riscv: dts: starfive: jh7110: Add ethernet device nodes
>       https://git.kernel.org/conor/c/1ff166c97972
> [2/2] riscv: dts: starfive: visionfive 2: Add configuration of gmac and phy
>       https://git.kernel.org/conor/c/b15a73c358d1
> 
> Thanks,
> Conor.


Hi Conor，

Thank you so much！ 

There is a question about the configuration of phy that I would like to consult you.

Latest on motorcomm PHY V5[1]: Follow Rob Herring's advice
motorcomm,rx-xxx-driver-strength Changed to motorcomm,rx-xxx-drv-microamp .
V5 has already received a reviewed-by from Andrew Lunn, and it should not change again.

Should I submit another pacthes based on riscv-dt-for-next? 

[1] https://patchwork.kernel.org/project/netdevbpf/cover/20230720111509.21843-1-samin.guo@starfivetech.com

 
Best regards,
Samin