[PATCH v6 03/14] drivers: irqchip/riscv-intc: Mark all INTC nodes as initialized

[Anup Patel]

The RISC-V INTC local interrupts are per-HART (or per-CPU) so
we create INTC IRQ domain only for the INTC node belonging to
the boot HART. This means only the boot HART INTC node will be
marked as initialized and other INTC nodes won't be marked which
results downstream interrupt controllers (such as IMSIC and APLIC
direct-mode) not being probed due to missing device suppliers.

To address this issue, we mark all INTC node for which we don't
create IRQ domain as initialized.

Signed-off-by: Anup Patel <apatel at ventanamicro.com>
---
 drivers/irqchip/irq-riscv-intc.c | 10 +++++++++-
 1 file changed, 9 insertions(+), 1 deletion(-)

diff --git a/drivers/irqchip/irq-riscv-intc.c b/drivers/irqchip/irq-riscv-intc.c
index 65f4a2afb381..4e2704bc25fb 100644
--- a/drivers/irqchip/irq-riscv-intc.c
+++ b/drivers/irqchip/irq-riscv-intc.c
@@ -155,8 +155,16 @@ static int __init riscv_intc_init(struct device_node *node,
 	 * for each INTC DT node. We only need to do INTC initialization
 	 * for the INTC DT node belonging to boot CPU (or boot HART).
 	 */
-	if (riscv_hartid_to_cpuid(hartid) != smp_processor_id())
+	if (riscv_hartid_to_cpuid(hartid) != smp_processor_id()) {
+		/*
+		 * The INTC nodes of each CPU are suppliers for downstream
+		 * interrupt controllers (such as IMSIC and APLIC direct-mode)
+		 * so we should mark an INTC node as initialized if we are
+		 * not creating IRQ domain for it.
+		 */
+		fwnode_dev_initialized(of_fwnode_handle(node), true);
 		return 0;
+	}
 
 	return riscv_intc_init_common(of_node_to_fwnode(node));
 }
-- 
2.34.1