[PATCH v3 5/7] dt-bindings: soc: starfive: Add StarFive syscon module

[Rob Herring]

On Mon, Apr 17, 2023 at 03:43:48PM +0800, Xingyu Wu wrote:
> On 2023/4/14 20:37, Rob Herring wrote:
> > 
> > On Fri, 14 Apr 2023 10:41:55 +0800, Xingyu Wu wrote:
> >> From: William Qiu <william.qiu at starfivetech.com>
> >> 
> >> Add documentation to describe StarFive System Controller Registers.
> >> 
> >> Signed-off-by: William Qiu <william.qiu at starfivetech.com>
> >> ---
> >>  .../soc/starfive/starfive,jh7110-syscon.yaml  | 58 +++++++++++++++++++
> >>  MAINTAINERS                                   |  6 ++
> >>  2 files changed, 64 insertions(+)
> >>  create mode 100644 Documentation/devicetree/bindings/soc/starfive/starfive,jh7110-syscon.yaml
> >> 
> > 
> > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
> > on your patch (DT_CHECKER_FLAGS is new in v5.13):
> > 
> > yamllint warnings/errors:
> > 
> > dtschema/dtc warnings/errors:
> > ./Documentation/devicetree/bindings/soc/starfive/starfive,jh7110-syscon.yaml: Unable to find schema file matching $id: http://devicetree.org/schemas/clock/starfive,jh7110-pll.yaml
> > 
> > doc reference errors (make refcheckdocs):
> > 
> > See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230414024157.53203-6-xingyu.wu@starfivetech.com
> > 
> > The base for the series is generally the latest rc1. A different dependency
> > should be noted in *this* patch.
> > 
> > If you already ran 'make dt_binding_check' and didn't see the above
> > error(s), then make sure 'yamllint' is installed and dt-schema is up to
> > date:
> > 
> > pip3 install dtschema --upgrade
> > 
> > Please check and re-submit after running the above command yourself. Note
> > that DT_SCHEMA_FILES can be set to your schema file to speed up checking
> > your schema. However, it must be unset to test all examples with your schema.
> > 
> 
> I have updated yamllint and dtschema, and tested it and didn't see this error.
> I asked william and also didn't see this. This error says the file:
> http://devicetree.org/schemas/clock/starfive,jh7110-pll.yaml was not found.
> This file is added in patch 1 but patch 1 should be applied after these patchset
> about JH7110 basic clock drivers. I don't know if that's the reason.

Yes, patch 1 could not be applied[1].

Rob

[1] https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230414024157.53203-2-xingyu.wu@starfivetech.com/