[PATCH v2 7/9] net: stmmac: Add glue layer for StarFive JH71x0 SoCs
Yanhong Wang
yanhong.wang at starfivetech.com
Thu Dec 15 23:06:30 PST 2022
This adds StarFive dwmac driver support on the StarFive JH71x0 SoCs.
Signed-off-by: Yanhong Wang <yanhong.wang at starfivetech.com>
Co-developed-by: Emil Renner Berthing <kernel at esmil.dk>
Signed-off-by: Emil Renner Berthing <kernel at esmil.dk>
---
MAINTAINERS | 1 +
drivers/net/ethernet/stmicro/stmmac/Kconfig | 12 ++
drivers/net/ethernet/stmicro/stmmac/Makefile | 1 +
.../stmicro/stmmac/dwmac-starfive-plat.c | 167 ++++++++++++++++++
4 files changed, 181 insertions(+)
create mode 100644 drivers/net/ethernet/stmicro/stmmac/dwmac-starfive-plat.c
diff --git a/MAINTAINERS b/MAINTAINERS
index 1ff68b8524d2..c7d3229330aa 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -19609,6 +19609,7 @@ F: include/dt-bindings/clock/starfive*
STARFIVE DWMAC GLUE LAYER
M: Yanhong Wang <yanhong.wang at starfivetech.com>
S: Maintained
+F: Documentation/devicetree/bindings/net/dwmac-starfive-plat.c
F: Documentation/devicetree/bindings/net/motorcomm,yt8531.yaml
F: Documentation/devicetree/bindings/net/starfive,jh71x0-dwmac.yaml
diff --git a/drivers/net/ethernet/stmicro/stmmac/Kconfig b/drivers/net/ethernet/stmicro/stmmac/Kconfig
index 31ff35174034..ca3d4dd95a95 100644
--- a/drivers/net/ethernet/stmicro/stmmac/Kconfig
+++ b/drivers/net/ethernet/stmicro/stmmac/Kconfig
@@ -235,6 +235,18 @@ config DWMAC_INTEL_PLAT
the stmmac device driver. This driver is used for the Intel Keem Bay
SoC.
+config DWMAC_STARFIVE_PLAT
+ tristate "StarFive dwmac support"
+ depends on OF && COMMON_CLK
+ depends on STMMAC_ETH
+ default SOC_STARFIVE
+ help
+ Support for ethernet controllers on StarFive RISC-V SoCs
+
+ This selects the StarFive platform specific glue layer support for
+ the stmmac device driver. This driver is used for StarFive JH71x0
+ ethernet controller.
+
config DWMAC_VISCONTI
tristate "Toshiba Visconti DWMAC support"
default ARCH_VISCONTI
diff --git a/drivers/net/ethernet/stmicro/stmmac/Makefile b/drivers/net/ethernet/stmicro/stmmac/Makefile
index d4e12e9ace4f..a63ab0ab5071 100644
--- a/drivers/net/ethernet/stmicro/stmmac/Makefile
+++ b/drivers/net/ethernet/stmicro/stmmac/Makefile
@@ -31,6 +31,7 @@ obj-$(CONFIG_DWMAC_DWC_QOS_ETH) += dwmac-dwc-qos-eth.o
obj-$(CONFIG_DWMAC_INTEL_PLAT) += dwmac-intel-plat.o
obj-$(CONFIG_DWMAC_GENERIC) += dwmac-generic.o
obj-$(CONFIG_DWMAC_IMX8) += dwmac-imx.o
+obj-$(CONFIG_DWMAC_STARFIVE_PLAT) += dwmac-starfive-plat.o
obj-$(CONFIG_DWMAC_VISCONTI) += dwmac-visconti.o
stmmac-platform-objs:= stmmac_platform.o
dwmac-altr-socfpga-objs := altr_tse_pcs.o dwmac-socfpga.o
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-starfive-plat.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-starfive-plat.c
new file mode 100644
index 000000000000..f8b68dd53c91
--- /dev/null
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-starfive-plat.c
@@ -0,0 +1,167 @@
+// SPDX-License-Identifier: GPL-2.0+
+/*
+ * StarFive DWMAC platform driver
+ *
+ * Copyright(C) 2022 StarFive Technology Co., Ltd.
+ *
+ */
+
+#include <linux/mfd/syscon.h>
+#include <linux/of_device.h>
+#include <linux/regmap.h>
+#include "stmmac_platform.h"
+
+struct starfive_dwmac {
+ struct device *dev;
+ struct clk *clk_tx;
+ struct clk *clk_gtx;
+ struct clk *clk_gtxc;
+};
+
+#define JH7100_SYSMAIN_REGISTER28 0x70
+/* The value below is not a typo, just really bad naming by StarFive ¯\_(ツ)_/¯ */
+#define JH7100_SYSMAIN_REGISTER49 0xc8
+
+static int starfive_eth_plat_jh7100_syscon_init(struct device *dev)
+{
+ struct device_node *np = dev->of_node;
+ struct regmap *sysmain;
+ u32 gtxclk_dlychain;
+ int ret;
+
+ sysmain = syscon_regmap_lookup_by_phandle(np, "starfive,syscon");
+ if (IS_ERR(sysmain))
+ return dev_err_probe(dev, PTR_ERR(sysmain),
+ "error getting sysmain registers\n");
+
+ /* Choose RGMII interface to the phy.
+ * TODO: support other interfaces once we know the meaning of other
+ * values in the register
+ */
+ ret = regmap_update_bits(sysmain, JH7100_SYSMAIN_REGISTER28, 0x7, 1);
+ if (ret)
+ return dev_err_probe(dev, ret, "error selecting gmac interface\n");
+
+ if (!of_property_read_u32(np, "starfive,gtxclk-dlychain", >xclk_dlychain)) {
+ ret = regmap_write(sysmain, JH7100_SYSMAIN_REGISTER49, gtxclk_dlychain);
+ if (ret)
+ return dev_err_probe(dev, ret, "error selecting gtxclk delay chain\n");
+ }
+
+ return 0;
+}
+
+static void starfive_eth_plat_fix_mac_speed(void *priv, unsigned int speed)
+{
+ struct starfive_dwmac *dwmac = priv;
+ unsigned long rate;
+ int err;
+
+ switch (speed) {
+ case SPEED_1000:
+ rate = 125000000;
+ break;
+ case SPEED_100:
+ rate = 25000000;
+ break;
+ case SPEED_10:
+ rate = 2500000;
+ break;
+ default:
+ dev_err(dwmac->dev, "invalid speed %u\n", speed);
+ return;
+ }
+
+ err = clk_set_rate(dwmac->clk_gtx, rate);
+ if (err)
+ dev_err(dwmac->dev, "failed to set tx rate %lu\n", rate);
+}
+
+static int starfive_eth_plat_probe(struct platform_device *pdev)
+{
+ struct plat_stmmacenet_data *plat_dat;
+ struct stmmac_resources stmmac_res;
+ struct starfive_dwmac *dwmac;
+ int (*syscon_init)(struct device *dev);
+ int err;
+
+ err = stmmac_get_platform_resources(pdev, &stmmac_res);
+ if (err)
+ return err;
+
+ plat_dat = stmmac_probe_config_dt(pdev, stmmac_res.mac);
+ if (IS_ERR(plat_dat)) {
+ dev_err(&pdev->dev, "dt configuration failed\n");
+ return PTR_ERR(plat_dat);
+ }
+
+ dwmac = devm_kzalloc(&pdev->dev, sizeof(*dwmac), GFP_KERNEL);
+ if (!dwmac)
+ return -ENOMEM;
+
+ syscon_init = of_device_get_match_data(&pdev->dev);
+ if (syscon_init) {
+ err = syscon_init(&pdev->dev);
+ if (err)
+ return err;
+ }
+
+ dwmac->clk_tx = devm_clk_get_enabled(&pdev->dev, "tx");
+ if (IS_ERR(dwmac->clk_tx))
+ return dev_err_probe(&pdev->dev, PTR_ERR(dwmac->clk_tx),
+ "error getting tx clock\n");
+
+ dwmac->clk_gtx = devm_clk_get_enabled(&pdev->dev, "gtx");
+ if (IS_ERR(dwmac->clk_gtx))
+ return dev_err_probe(&pdev->dev, PTR_ERR(dwmac->clk_gtx),
+ "error getting gtx clock\n");
+
+ /* Only StarFive JH7110 SoC support gtxc clock */
+ if (of_device_is_compatible(pdev->dev.of_node, "starfive,jh7110-dwmac")) {
+ dwmac->clk_gtxc = devm_clk_get_enabled(&pdev->dev, "gtxc");
+ if (IS_ERR(dwmac->clk_gtxc))
+ return dev_err_probe(&pdev->dev, PTR_ERR(dwmac->clk_gtxc),
+ "error getting gtxc clock\n");
+ }
+
+ dwmac->dev = &pdev->dev;
+ plat_dat->fix_mac_speed = starfive_eth_plat_fix_mac_speed;
+ plat_dat->init = NULL;
+ plat_dat->bsp_priv = dwmac;
+ plat_dat->dma_cfg->dche = true;
+
+ err = stmmac_dvr_probe(&pdev->dev, plat_dat, &stmmac_res);
+ if (err) {
+ stmmac_remove_config_dt(pdev, plat_dat);
+ return err;
+ }
+
+ return 0;
+}
+
+static const struct of_device_id starfive_eth_plat_match[] = {
+ {
+ .compatible = "starfive,jh7110-dwmac"
+ },
+ {
+ .compatible = "starfive,jh7100-dwmac",
+ .data = starfive_eth_plat_jh7100_syscon_init,
+ },
+ { }
+};
+
+static struct platform_driver starfive_eth_plat_driver = {
+ .probe = starfive_eth_plat_probe,
+ .remove = stmmac_pltfr_remove,
+ .driver = {
+ .name = "starfive-eth-plat",
+ .pm = &stmmac_pltfr_pm_ops,
+ .of_match_table = starfive_eth_plat_match,
+ },
+};
+
+module_platform_driver(starfive_eth_plat_driver);
+
+MODULE_LICENSE("GPL");
+MODULE_DESCRIPTION("StarFive DWMAC platform driver");
+MODULE_AUTHOR("Yanhong Wang <yanhong.wang at starfivetech.com>");
--
2.17.1
More information about the linux-riscv
mailing list