what is PCI to PCMCIA adaptor device name

[Simon Wu]

On 7/11/06, Larry Finger <Larry.Finger at lwfinger.net> wrote:
> Simon Wu wrote:
> >  installed a PCI to PCMCIA card adaptor in my desktop PC with Fedora
> > 3. Apparently, it is detected as Ismod shows:
> > yenta_socket   21705  1
> > rsrc_nonstatic  12737  1 yenta_socket
> > pcmcia_core    50013  2 yenta_socket, rsrc_nonstatic
> >
> > I have a 3G wireless modem connected to th adaptor.
> >
> > However, I couldn't find a device name under /dev/. Can someone tell
> > me what and where is the device name? Is it configurable?
>
> Is this a PCMCIA or CardBus device? If the latter, which I suspect, the device particulars will show
> up with the PCI data. Check the full output of "lspci -v" and check for an entry that starts with
> 03:00.0, which is where the new interface should appear. The 03 comes from the secondary Bus listed
> below. If your device does show up there, also do an "lspci -n". My wireless interface reports
> "02:00.0 Class 0280: 14e4:4320 (rev 02)". Of importance are the numbers in the position where I have
> 14e4:4320. For a driver to attach to the device, its internal tables must match these values.
>
> > By the way, the lspci shows:
> > 02:0a.0 CardBus bridge: Ricoh Co Ltd RL5c475 (rev 81)
> >        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
> > ParErr- Stepping- SERR- FastB2B-
> >        Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium
> >> TAbort- <TAbort- <MAbort- >SERR- <PERR-
> >        Latency: 168
> >        Interrupt: pin A routed to IRQ 11
> >        Region 0: Memory at 20000000 (32-bit, non-prefetchable) [size=4K]
> >        Bus: primary=02, secondary=03, subordinate=06, sec-latency=176
> >        Memory window 0: 20400000-207ff000 (prefetchable)
> >        Memory window 1: 20800000-20bff000
> >        I/O window 0: 00004000-000040ff
> >        I/O window 1: 00004400-000044ff
> >        BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt- PostWrite+
> >        16-bit legacy interface ports at 0001
>
> Larry
>
>

Thanks Larry. "lspci -v" shows the following.

02:0a.0 CardBus bridge: Ricoh Co Ltd RL5c475 (rev 81)
        Flags: bus master, medium devsel, latency 168, IRQ 11
        Memory at 20000000 (32-bit, non-prefetchable) [size=4K]
        Bus: primary=02, secondary=03, subordinate=06, sec-latency=176
        Memory window 0: 20400000-207ff000 (prefetchable)
        Memory window 1: 20800000-20bff000
        I/O window 0: 00004000-000040ff
        I/O window 1: 00004400-000044ff
        16-bit legacy interface ports at 0001

I couldn't find the information you described. But if it works, where
and what name should my data card (3G Wireless modem) be?

Simon