Problem with yenta_socket (unable to map card memory) - PROGRESS

[David Hinds]

On Sat, Jul 10, 2004 at 08:48:13PM -0700, Jeff Morrow wrote:
> 
> Those were all I saw at the time.  Just tried it again.  Did 
> /etc/init.d/pcmcia restart and it was normal (said "watching 1 socket", 
> etc).
> 
> Then I put in the card and got one high beep but no lights. 

Are you sure that was not a low beep?

> Checked dmesg and saw this:
> 
> Linux Kernel Card Services
>   options:  [pci] [cardbus] [pm]
> Yenta: CardBus bridge found at 0000:01:0a.0 [0000:0000]
> Yenta: ISA IRQ mask 0x0000, PCI irq 10
> Socket status: 30000086
> cs: IO port probe 0x0100-0x04ff: excluding 0x290-0x297 0x4d0-0x4d7
> cs: IO port probe 0x0800-0x08ff: clean.
> cs: IO port probe 0x0c00-0x0cff: clean.
> cs: IO port probe 0x0a00-0x0aff: clean.
> cs: IO port probe 0xa000-0xbfff: clean.
> cs: pcmcia_socket0: voltage interrogation timed out.
> 
> Then I typed "cardctl insert" at a command line and dmesg added this:
> 
> cs: memory probe 0xe4000000-0xe4ffffff: excluding 0xe4000000-0xe40fffff

There are additional messages from cardmgr wherever you saw the
"watching 1 socket" message, probably /var/log/messages.

-- Dave