[Linux-parport] [PATCH 4/4] pata_parport-fit3: implement IDE command set registers

[Sergey Shtylyov]

On 9/30/23 10:15 PM, Ondrej Zary wrote:

> fit3 protocol driver does not support accessing IDE control registers
> (device control/altstatus). The DOS driver does not use these registers
> either (as observed from DOSEMU trace). But the HW seems to be capable
> of accessing these registers - I simply tried bit 3 and it works!
> 
> The control register is required to properly reset ATAPI devices or
> they will be detected only once (after a power cycle).
> 
> Tested with EXP Computer CD-865 with MC-1285B EPP cable and
> TransDisk 3000.
> 
> Signed-off-by: Ondrej Zary <linux at zary.sk>
> ---
>  drivers/ata/pata_parport/fit3.c | 16 ++++------------
>  1 file changed, 4 insertions(+), 12 deletions(-)
> 
> diff --git a/drivers/ata/pata_parport/fit3.c b/drivers/ata/pata_parport/fit3.c
> index bad7aa920cdc..86b39966755b 100644
> --- a/drivers/ata/pata_parport/fit3.c
> +++ b/drivers/ata/pata_parport/fit3.c
[...]
> @@ -35,10 +30,11 @@
>   * cont = 1 - access the IDE command set
>   */
>  
> +static int cont_map[] = { 0x00, 0x08 };

   const?

> +
>  static void fit3_write_regr(struct pi_adapter *pi, int cont, int regr, int val)
>  {
> -	if (cont == 1)
> -		return;
> +	regr += cont_map[cont];

   Perhaps regr += cont << 3 instead?

>  
>  	switch (pi->mode) {
>  	case 0:
> @@ -59,11 +55,7 @@ static int fit3_read_regr(struct pi_adapter *pi, int cont, int regr)
>  {
>  	int  a, b;
>  
> -	if (cont) {
> -		if (regr != 6)
> -			return 0xff;
> -		regr = 7;
> -	}
> +	regr += cont_map[cont];

   Likewise here?

[...]

MBR, Sergey