[PATCH] nvme: Move nvme_setup_cmd before hot_pathing

[Justin Tee]

Hi Minsik,

 > diff --git a/drivers/nvme/host/fc.c b/drivers/nvme/host/fc.c
 > index e1bb4707183c..8ea37102a836 100644
 > --- a/drivers/nvme/host/fc.c
 > +++ b/drivers/nvme/host/fc.c
 > @@ -2762,14 +2762,14 @@ nvme_fc_queue_rq(struct blk_mq_hw_ctx *hctx,
 >         u32 data_len;
 >         blk_status_t ret;
 >
 > -       if (ctrl->rport->remoteport.port_state != FC_OBJSTATE_ONLINE ||
 > -           !nvme_check_ready(&queue->ctrl->ctrl, rq, queue_ready))
 > -               return nvme_fail_nonready_command(&queue->ctrl->ctrl, 
rq);
 > -
 >         ret = nvme_setup_cmd(ns, rq);
 >         if (ret)
 >                 return ret;
 >
 > +       if (ctrl->rport->remoteport.port_state != FC_OBJSTATE_ONLINE ||
 > +           !nvme_check_ready(&queue->ctrl->ctrl, rq, queue_ready))
 > +               return nvme_fail_nonready_command(&queue->ctrl->ctrl, 
rq);
 > +

__nvme_check_ready() checks for (nvme_req(req)->flags & 
NVME_REQ_USERCMD).  In nvme_setup_cmd(), nvme_clear_nvme_request() 
clears the nvme_req(req)->flags when RQF_DONTPREP is not set.

Is it possible that this patch would have nvme_setup_cmd() erase a 
nvme_req(req)’s NVME_REQ_USERCMD flag before __nvme_check_ready() is 
called for each respective .queue_rq?

Regards,
Justin Tee