[PATCH 1/1] nvme-pci: Add CPU latency pm-qos handling

[Tero Kristo]

On Tue, 2024-10-15 at 15:29 +0200, Christoph Hellwig wrote:
> On Tue, Oct 15, 2024 at 12:25:37PM +0300, Tero Kristo wrote:
> > I've been giving this some thought offline, but can't really think
> > of
> > how this could be done in the generic layers; the code needs to
> > figure
> > out the interrupt that gets fired by the activity, to prevent the
> > CPU
> > that is going to handle that interrupt to go into deep idle,
> > potentially ruining the latency and throughput of the request. The
> > knowledge of this interrupt mapping only resides in the driver
> > level,
> > in this case NVMe.
> > 
> > One thing that could be done is to prevent the whole feature to be
> > used
> > on setups where the number of cpus per irq is above some threshold;
> > lets say 4 as an example.
> 
> As a disclaimer I don't really understand the PM QOS framework, just
> the NVMe driver and block layer.
> 
> With that my gut feeling is that all this latency management should
> be driven by the blk_mq_hctx structure, the block layer equivalent
> to a queue.  And instead of having a per-cpu array of QOS requests
> per device, there should one per cpu in the actual mask of the
> hctx, so that you only have to iterate this local shared data
> structure.
> 
> Preferably there would be one single active check per hctx and
> not one per cpu, e.g. when the block layer submits commands
> it has to do one single check instead of an iteration.  Similarly
> the block layer code would time out the activity once per hctx,
> and only then iterate the (usually few) CPUs per hctx.
> 

Thanks for the feedback, I have now reworked + retested my patches
against blk-mq, just posted them to the block mailing list also.

-Tero