[PATCH RESEND] nvme-pci: Fix EEH failure on ppc after subsystem reset
Nilay Shroff
nilay at linux.ibm.com
Thu Feb 8 21:02:16 PST 2024
If the nvme subsyetm reset causes the loss of communication to the nvme
adapter then EEH could potnetially recover the adapter. The detection of
comminication loss to the adapter only happens when the nvme driver
attempts to read an MMIO register.
The nvme subsystem reset command writes 0x4E564D65 to NSSR register and
schedule adapter reset.In the case nvme subsystem reset caused the loss
of communication to the nvme adapter then either IO timeout event or
adapter reset handler could detect it. If IO timeout even could detect
loss of communication then EEH handler is able to recover the
communication to the adapter. This change was implemented in 651438bb0af5
(nvme-pci: Fix EEH failure on ppc). However if the adapter communication
loss is detected in nvme reset work handler then EEH is unable to
successfully finish the adapter recovery.
This patch ensures that,
- nvme driver reset handler would observer pci channel was offline after
a failed MMIO read and avoids marking the controller state to DEAD and
thus gives a fair chance to EEH handler to recover the nvme adapter.
- if nvme controller is already in RESETTNG state and pci channel frozen
error is detected then nvme driver pci-error-handler code sends the
correct error code (PCI_ERS_RESULT_NEED_RESET) back to the EEH handler
so that EEH handler could proceed with the pci slot reset.
Signed-off-by: Nilay Shroff <nilay at linux.ibm.com>
[ 131.415601] EEH: Recovering PHB#40-PE#10000
[ 131.415619] EEH: PE location: N/A, PHB location: N/A
[ 131.415623] EEH: Frozen PHB#40-PE#10000 detected
[ 131.415627] EEH: Call Trace:
[ 131.415629] EEH: [c000000000051078] __eeh_send_failure_event+0x7c/0x15c
[ 131.415782] EEH: [c000000000049bdc] eeh_dev_check_failure.part.0+0x27c/0x6b0
[ 131.415789] EEH: [c000000000cb665c] nvme_pci_reg_read32+0x78/0x9c
[ 131.415802] EEH: [c000000000ca07f8] nvme_wait_ready+0xa8/0x18c
[ 131.415814] EEH: [c000000000cb7070] nvme_dev_disable+0x368/0x40c
[ 131.415823] EEH: [c000000000cb9970] nvme_reset_work+0x198/0x348
[ 131.415830] EEH: [c00000000017b76c] process_one_work+0x1f0/0x4f4
[ 131.415841] EEH: [c00000000017be2c] worker_thread+0x3bc/0x590
[ 131.415846] EEH: [c00000000018a46c] kthread+0x138/0x140
[ 131.415854] EEH: [c00000000000dd58] start_kernel_thread+0x14/0x18
[ 131.415864] EEH: This PCI device has failed 1 times in the last hour and will be permanently disabled after 5 failures.
[ 131.415874] EEH: Notify device drivers to shutdown
[ 131.415882] EEH: Beginning: 'error_detected(IO frozen)'
[ 131.415888] PCI 0040:01:00.0#10000: EEH: Invoking nvme->error_detected(IO frozen)
[ 131.415891] nvme nvme1: frozen state error detected, reset controller
[ 131.515358] nvme 0040:01:00.0: enabling device (0000 -> 0002)
[ 131.515778] nvme nvme1: Disabling device after reset failure: -19
[ 131.555336] PCI 0040:01:00.0#10000: EEH: nvme driver reports: 'disconnect'
[ 131.555343] EEH: Finished:'error_detected(IO frozen)' with aggregate recovery state:'disconnect'
[ 131.555371] EEH: Unable to recover from failure from PHB#40-PE#10000.
[ 131.555371] Please try reseating or replacing it
[ 131.556296] EEH: of node=0040:01:00.0
[ 131.556351] EEH: PCI device/vendor: 00251e0f
[ 131.556421] EEH: PCI cmd/status register: 00100142
[ 131.556428] EEH: PCI-E capabilities and status follow:
[ 131.556678] EEH: PCI-E 00: 0002b010 10008fe3 00002910 00436044
[ 131.556859] EEH: PCI-E 10: 10440000 00000000 00000000 00000000
[ 131.556869] EEH: PCI-E 20: 00000000
[ 131.556875] EEH: PCI-E AER capability register set follows:
[ 131.557115] EEH: PCI-E AER 00: 14820001 00000000 00400000 00462030
[ 131.557294] EEH: PCI-E AER 10: 00000000 0000e000 000002a0 00000000
[ 131.557469] EEH: PCI-E AER 20: 00000000 00000000 00000000 00000000
[ 131.557523] EEH: PCI-E AER 30: 00000000 00000000
[ 131.558807] EEH: Beginning: 'error_detected(permanent failure)'
[ 131.558815] PCI 0040:01:00.0#10000: EEH: Invoking nvme->error_detected(permanent failure)
[ 131.558818] nvme nvme1: failure state error detected, request disconnect
[ 131.558839] PCI 0040:01:00.0#10000: EEH: nvme driver reports: 'disconnect'
---
drivers/nvme/host/pci.c | 16 +++++++++++++---
1 file changed, 13 insertions(+), 3 deletions(-)
diff --git a/drivers/nvme/host/pci.c b/drivers/nvme/host/pci.c
index c1d6357ec98a..a6ba46e727ba 100644
--- a/drivers/nvme/host/pci.c
+++ b/drivers/nvme/host/pci.c
@@ -2776,6 +2776,14 @@ static void nvme_reset_work(struct work_struct *work)
out_unlock:
mutex_unlock(&dev->shutdown_lock);
out:
+ /*
+ * If PCI recovery is ongoing then let it finish first
+ */
+ if (pci_channel_offline(to_pci_dev(dev->dev))) {
+ dev_warn(dev->ctrl.device, "PCI recovery is ongoing so let it finish\n");
+ return;
+ }
+
/*
* Set state to deleting now to avoid blocking nvme_wait_reset(), which
* may be holding this pci_dev's device lock.
@@ -3295,9 +3303,11 @@ static pci_ers_result_t nvme_error_detected(struct pci_dev *pdev,
case pci_channel_io_frozen:
dev_warn(dev->ctrl.device,
"frozen state error detected, reset controller\n");
- if (!nvme_change_ctrl_state(&dev->ctrl, NVME_CTRL_RESETTING)) {
- nvme_dev_disable(dev, true);
- return PCI_ERS_RESULT_DISCONNECT;
+ if (nvme_ctrl_state(&dev->ctrl) != NVME_CTRL_RESETTING) {
+ if (!nvme_change_ctrl_state(&dev->ctrl, NVME_CTRL_RESETTING)) {
+ nvme_dev_disable(dev, true);
+ return PCI_ERS_RESULT_DISCONNECT;
+ }
}
nvme_dev_disable(dev, false);
return PCI_ERS_RESULT_NEED_RESET;
--
2.43.0
More information about the Linux-nvme
mailing list