[PATCH v5 6/6] nvmet: return DHCHAP status codes from nvmet_setup_auth()

[Hannes Reinecke]

On 4/9/24 22:23, Sagi Grimberg wrote:
> 
> 
> On 09/04/2024 12:35, Daniel Wagner wrote:
>> From: Hannes Reinecke <hare at kernel.org>
>>
>> A failure in nvmet_setup_auth() does not mean that the NVMe
>> authentication command failed, so we should rather return a protocol
>> error with a 'failure1' response than an NVMe status.
>>
>> Also update the type used for dhchap_step and dhchap_status to u8 to
>> avoid confusions with nvme status. Furthermore, split dhchap_status and
>> nvme status so we don't accidentally mix these return values.
> 
> What is the implications of this on the host behavior? In other
> words, why is this a part of the series?

This issue came up during testing the series, where we found that the 
target would cause connection failure (ie return the NVMe CQE with a
status code) rather than a protocol error (ie return the NVMe CQE
with a 'good' status, and set the 'failure1' status for DH-CHAP).
And with that a termination of the DH-CHAP protocol, and not
a connection reset.
So not directly related, but required to get the testcase for this
series working.

Cheers,

Hannes
-- 
Dr. Hannes Reinecke                  Kernel Storage Architect
hare at suse.de                                +49 911 74053 688
SUSE Software Solutions GmbH, Frankenstr. 146, 90461 Nürnberg
HRB 36809 (AG Nürnberg), GF: I. Totev, A. McDonald, W. Knoblich