[PATCH 04/16] block: allow blk-zoned devices to have non-power-of-2 zone size

[Pankaj Raghav]

Convert the calculations on zone size to be generic instead of relying on
power_of_2 based logic in the block layer using the helpers wherever
possible.

The only hot path affected by this change for power_of_2 zoned devices
is in blk_check_zone_append() but the effects should be negligible as the
helper blk_queue_zone_aligned() optimizes the calculation for those
devices. Note that the append path cannot be accessed by direct raw access
to the block device but only through a filesystem abstraction.

Finally, remove the check for power_of_2 zone size requirement in
blk-zoned.c

Reviewed-by: Luis Chamberlain <mcgrof at kernel.org>
Signed-off-by: Pankaj Raghav <p.raghav at samsung.com>
---
 block/blk-core.c  |  3 +--
 block/blk-zoned.c | 12 ++++++------
 2 files changed, 7 insertions(+), 8 deletions(-)

diff --git a/block/blk-core.c b/block/blk-core.c
index 937bb6b86331..850caf311064 100644
--- a/block/blk-core.c
+++ b/block/blk-core.c
@@ -634,8 +634,7 @@ static inline blk_status_t blk_check_zone_append(struct request_queue *q,
 		return BLK_STS_NOTSUPP;
 
 	/* The bio sector must point to the start of a sequential zone */
-	if (pos & (blk_queue_zone_sectors(q) - 1) ||
-	    !blk_queue_zone_is_seq(q, pos))
+	if (!blk_queue_zone_aligned(q, pos) || !blk_queue_zone_is_seq(q, pos))
 		return BLK_STS_IOERR;
 
 	/*
diff --git a/block/blk-zoned.c b/block/blk-zoned.c
index 1dff4a8bd51d..f7c7c3bd148d 100644
--- a/block/blk-zoned.c
+++ b/block/blk-zoned.c
@@ -288,10 +288,10 @@ int blkdev_zone_mgmt(struct block_device *bdev, enum req_opf op,
 		return -EINVAL;
 
 	/* Check alignment (handle eventual smaller last zone) */
-	if (sector & (zone_sectors - 1))
+	if (!blk_queue_zone_aligned(q, sector))
 		return -EINVAL;
 
-	if ((nr_sectors & (zone_sectors - 1)) && end_sector != capacity)
+	if (!blk_queue_zone_aligned(q, nr_sectors) && end_sector != capacity)
 		return -EINVAL;
 
 	/*
@@ -489,14 +489,14 @@ static int blk_revalidate_zone_cb(struct blk_zone *zone, unsigned int idx,
 	 * smaller last zone.
 	 */
 	if (zone->start == 0) {
-		if (zone->len == 0 || !is_power_of_2(zone->len)) {
-			pr_warn("%s: Invalid zoned device with non power of two zone size (%llu)\n",
-				disk->disk_name, zone->len);
+		if (zone->len == 0) {
+			pr_warn("%s: Invalid zoned device size",
+				disk->disk_name);
 			return -ENODEV;
 		}
 
 		args->zone_sectors = zone->len;
-		args->nr_zones = (capacity + zone->len - 1) >> ilog2(zone->len);
+		args->nr_zones = div64_u64(capacity + zone->len - 1, zone->len);
 	} else if (zone->start + args->zone_sectors < capacity) {
 		if (zone->len != args->zone_sectors) {
 			pr_warn("%s: Invalid zoned device with non constant zone size\n",
-- 
2.25.1