PCIe unsupported request with Intel 760p

Keith Busch keith.busch at linux.intel.com
Mon May 7 08:12:47 PDT 2018


On Mon, May 07, 2018 at 06:43:54AM -0700, Matthew Wilcox wrote:
> On Mon, May 07, 2018 at 08:30:35AM -0400, Aron Griffis wrote:
> > I'm getting this error continuously with an Intel 760p on 4.16.5 (Fedora 28)
> > 
> > pcieport 0000:00:1d.0: AER: Uncorrected (Non-Fatal) error received: id=00e8
> > pcieport 0000:00:1d.0: PCIe Bus Error: severity=Uncorrected (Non-Fatal), type=Transaction Layer, id=00e8(Requester ID)
> > pcieport 0000:00:1d.0:   device [8086:a298] error status/mask=00100000/00010000
> > pcieport 0000:00:1d.0:    [20] Unsupported Request    (First)
> > pcieport 0000:00:1d.0:   TLP Header: 34000000 70000010 00000000 88468846
> > pcieport 0000:00:1d.0: broadcast error_detected message
> > pcieport 0000:00:1d.0: broadcast mmio_enabled message
> > pcieport 0000:00:1d.0: broadcast resume message
> > pcieport 0000:00:1d.0: AER: Device recovery successful
> > 
> > Willy graciously decoded this for me to a "Latency Tolerance Reporting
> > Message," and suggested I send email to this list to check whether it's a
> > problem with the device or driver.
> 
> Decoding this further, the Requester ID is 70:00.0 (ie the NVMe device is
> sending the LTR message) so the Root Port is the one saying "Unsupported
> Request".  Which is fair enough, because ...
> 
> > 00:1d.0 PCI bridge: Intel Corporation 200 Series PCH PCI Express Root Port #9 (rev f0) (prog-if 00 [Normal decode])
> > 	Bus: primary=00, secondary=70, subordinate=70, sec-latency=0
> > 		DevCap2: Completion Timeout: Range ABC, TimeoutDis+, LTR-, OBFF Not Supported ARIFwd+
> > 			 AtomicOpsCap: Routing- 32bit- 64bit- 128bitCAS-
> > 		DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR-, OBFF Disabled ARIFwd-
> > 			 AtomicOpsCtl: ReqEn- EgressBlck-
> 
> the Root Port doesn't know what LTR is.
> 
> > 70:00.0 Non-Volatile memory controller: Intel Corporation Device f1a6 (rev 03) (prog-if 02 [NVM Express])
> > 	Capabilities: [70] Express (v2) Endpoint, MSI 00
> > 		DevCap2: Completion Timeout: Range ABCD, TimeoutDis+, LTR+, OBFF Not Supported
> > 			 AtomicOpsCap: 32bit- 64bit- 128bitCAS-
> > 		DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR-, OBFF Disabled
> > 			 AtomicOpsCtl: ReqEn-
> 
> The device *does* know what LTR is, but it's supposed to be disabled.
> 
> Is there more recent firmware for this device?

Hi Willy,

Thank you for the detailed analysis. :)

I'm not familiar with this device, but I'll check internally to see if
this a later firmware release address this.

Aron,
Could you let me know the firmware revision you're currently running?

Thanks,
Keith



More information about the Linux-nvme mailing list