[PATCH v5 3/5] dt-bindings: mtd: spi-nor: add OTP parameters

[Erez Geva]

From: Erez Geva <ErezGeva2 at gmail.com>

Some flash devices need OTP parameters in device tree.
As we can not deduce the parameters based on JEDEC ID or SFDP.

Signed-off-by: Erez Geva <ErezGeva2 at gmail.com>
---
 .../bindings/mtd/jedec,spi-nor.yaml           | 39 +++++++++++++++++++
 1 file changed, 39 insertions(+)

diff --git a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
index 6e3afb42926e..4f7bb3f41cb1 100644
--- a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
+++ b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
@@ -90,6 +90,43 @@ properties:
       the SRWD bit while writing the status register. WP# signal hard strapped to GND
       can be a valid use case.
 
+  otp-n-regions:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    description:
+      Some flash devices need OTP parameters in the device tree.
+      As we can not deduce the parameters based on JEDEC ID or SFDP.
+      This parameter indicates the number of OTP regions.
+      The value must be larger or equal to 1 and mandatory for OTP.
+
+  otp-len:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    description:
+      Some flash devices need OTP parameters in the device tree.
+      As we can not deduce the parameters based on JEDEC ID or SFDP.
+      This parameter indicates the size (length) in bytes of an OTP region.
+      Currently the driver supports symmetric OTP,
+       which means all regions must use the same size.
+      The value must be positive and mandatory for OTP.
+
+  otp-offset:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    description:
+      Some flash devices need OTP parameters in the device tree.
+      As we can not deduce the parameters based on JEDEC ID or SFDP.
+      This parameter indicates the offset in bytes of
+       an OTP region relative to its previous.
+      User can omit it if the offset equals the length.
+      Or in case we have a single OTP region.
+
+  otp-base:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    description:
+      Some flash devices need OTP parameters in the device tree.
+      As we can not deduce the parameters based on JEDEC ID or SFDP.
+      This parameter indicates the base in bytes of the first OTP region.
+      User can omit it if the base is zero.
+      I.e. the address of the first OTP region starts from 0.
+
   reset-gpios:
     description:
       A GPIO line connected to the RESET (active low) signal of the device.
@@ -118,6 +155,8 @@ examples:
             spi-max-frequency = <40000000>;
             m25p,fast-read;
             reset-gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
+            otp-len = <512>;
+            otp-n-regions = <1>;
         };
     };
 ...
-- 
2.39.5