[PATCH] mtd: rawnand: qcom: Rename parameter name in macro

[Md Sadre Alam]

This change will rename parameter name in macro
nandc_set_read_loc().renamed parameter names are
cw_offset, read_size, is_last_read_loc.
Sinc in QPIC V2 on-wards there is separate location
register to read last code word, so to just differnciate
b/w is_last_read_loc from last_cw this change needed.

Signed-off-by: Md Sadre Alam <mdalam at codeaurora.org>
---
 drivers/mtd/nand/raw/qcom_nandc.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index 4189a7f..bfefb4e 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -181,11 +181,11 @@
 #define	ECC_BCH_4BIT	BIT(2)
 #define	ECC_BCH_8BIT	BIT(3)
 
-#define nandc_set_read_loc(nandc, reg, offset, size, is_last)	\
+#define nandc_set_read_loc(nandc, reg, cw_offset, read_size, is_last_read_loc)	\
 nandc_set_reg(nandc, NAND_READ_LOCATION_##reg,			\
-	      ((offset) << READ_LOCATION_OFFSET) |		\
-	      ((size) << READ_LOCATION_SIZE) |			\
-	      ((is_last) << READ_LOCATION_LAST))
+	      ((cw_offset) << READ_LOCATION_OFFSET) |		\
+	      ((read_size) << READ_LOCATION_SIZE) |			\
+	      ((is_last_read_loc) << READ_LOCATION_LAST))
 
 /*
  * Returns the actual register address for all NAND_DEV_ registers
-- 
2.7.4