[PATCH] mtd: nand: gpmi-nand: Remove wrong Kconfig help text

[Boris Brezillon]

On Fri, 17 Nov 2017 12:09:12 +0100
Sascha Hauer <s.hauer at pengutronix.de> wrote:

> The GPMI nand Kconfig help texts mentions that the GPMI nand driver
> might conflict with SD cards. The only conflict there might really
> be is that both controllers use the same pins, but this is resolved
> by the pincontroller setup in the device tree. In any way the GPMI
> driver can safely be enabled, the text is just wrong. Remove it.

Applied.

Thanks,

Boris

> 
> Signed-off-by: Sascha Hauer <s.hauer at pengutronix.de>
> ---
>  drivers/mtd/nand/Kconfig | 4 +---
>  1 file changed, 1 insertion(+), 3 deletions(-)
> 
> diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
> index 3f2036f31da4..8f4c288cf9f1 100644
> --- a/drivers/mtd/nand/Kconfig
> +++ b/drivers/mtd/nand/Kconfig
> @@ -373,9 +373,7 @@ config MTD_NAND_GPMI_NAND
>  	 Enables NAND Flash support for IMX23, IMX28 or IMX6.
>  	 The GPMI controller is very powerful, with the help of BCH
>  	 module, it can do the hardware ECC. The GPMI supports several
> -	 NAND flashs at the same time. The GPMI may conflicts with other
> -	 block, such as SD card. So pay attention to it when you enable
> -	 the GPMI.
> +	 NAND flashs at the same time.
>  
>  config MTD_NAND_BRCMNAND
>  	tristate "Broadcom STB NAND controller"