[PATCH] mtd: nand: fix interpretation of NAND_CMD_NONE in core ->cmdfunc()

[Miquel RAYNAL]

Hi Boris,

> How about rewording it like that:
> 
> "
> Some drivers (like nand_hynix.c) call ->cmdfunc() with NAND_CMD_NONE
> and a column address and expect the controller to only send address
> cycles. Right now, the default ->cmdfunc() implementations provided by
> the core do not filter out the command cycle in this case and forwards
> the request to the controller driver through the ->cmd_ctrl() method.
> The thing is, NAND controller drivers can get is wrong and send a
> command cycle with a NAND_CMD_NONE opcode and since NAND_CMD_NONE is
> -1, and the command field is usually casted to an u8, we end up
> sending the 0xFF command which is actually a RESET operation.
> 
> 
> Add conditions in nand_command[_lp]() functions to sending the initial
> command cycle when command == NAND_CMD_NONE.
> "

This is better explained. I put yours, with
s/drivers can get is wrong/drivers can get this wrong/

> 
> > 
> > Signed-off-by: Miquel Raynal <miquel.raynal at free-electrons.com>
> > ---
> >  drivers/mtd/nand/nand_base.c | 7 +++++--
> >  1 file changed, 5 insertions(+), 2 deletions(-)
> > 
> > diff --git a/drivers/mtd/nand/nand_base.c
> > b/drivers/mtd/nand/nand_base.c index c63e4a88a653..851f25383622
> > 100644 --- a/drivers/mtd/nand/nand_base.c
> > +++ b/drivers/mtd/nand/nand_base.c
> > @@ -710,7 +710,8 @@ static void nand_command(struct mtd_info *mtd,
> > unsigned int command, chip->cmd_ctrl(mtd, readcmd, ctrl);
> >  		ctrl &= ~NAND_CTRL_CHANGE;
> >  	}
> > -	chip->cmd_ctrl(mtd, command, ctrl);
> > +	if (command != NAND_CMD_NONE)
> > +		chip->cmd_ctrl(mtd, command, ctrl);
> >  
> >  	/* Address cycle, when necessary */
> >  	ctrl = NAND_CTRL_ALE | NAND_CTRL_CHANGE;  
> 
> You should probably also add a new case in the switch-case block to
> bail-out when command == NAND_CMD_NONE.

Oh that is right, there is nothing to wait for in that case.

Thank you,
Miquèl