[PATCH 3/3][v3] mtd: nand: davinci: set ECC algorithm explicitly for HW based ECC

[Boris Brezillon]

On Tue,  2 May 2017 10:13:23 +0200
Alexander Couzens <lynxis at fe80.eu> wrote:

> Required to set the ooblayout based on the algorithm.

Not strictly required if you take my comment into account (see my
reply to patch 2). This being said, it's always to have this kind of
information, I'll just have to check if it doesn't conflict with
Masahiro's patches.

> 
> Signed-off-by: Alexander Couzens <lynxis at fe80.eu>
> ---
>  drivers/mtd/nand/davinci_nand.c | 4 +++-
>  1 file changed, 3 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/mtd/nand/davinci_nand.c b/drivers/mtd/nand/davinci_nand.c
> index 27fa8b87cd5f..9e5167496ce1 100644
> --- a/drivers/mtd/nand/davinci_nand.c
> +++ b/drivers/mtd/nand/davinci_nand.c
> @@ -760,11 +760,13 @@ static int nand_davinci_probe(struct platform_device *pdev)
>  			info->chip.ecc.hwctl = nand_davinci_hwctl_4bit;
>  			info->chip.ecc.bytes = 10;
>  			info->chip.ecc.options = NAND_ECC_GENERIC_ERASED_CHECK;
> -		} else {
> +			info->chip.ecc.algo = NAND_ECC_BCH;
> +		} else { /* 1bit ecc hamming */

Please put this comment on the next line.

>  			info->chip.ecc.calculate = nand_davinci_calculate_1bit;
>  			info->chip.ecc.correct = nand_davinci_correct_1bit;
>  			info->chip.ecc.hwctl = nand_davinci_hwctl_1bit;
>  			info->chip.ecc.bytes = 3;
> +			info->chip.ecc.algo = NAND_ECC_HAMMING;
>  		}
>  		info->chip.ecc.size = 512;
>  		info->chip.ecc.strength = pdata->ecc_bits;