Multiple NANDs on non contiguous chip selects, how?

[Boris Brezillon]

Hi Sacha,

On Mon, 15 Feb 2016 13:22:52 +0100
Sascha Hauer <s.hauer at pengutronix.de> wrote:

> Hi all,
> 
> I have a i.MX6 board here which has two NAND chips connected to CS0 and
> CS2 on the same controller. The current code in nand_scan_ident iterates
> over the chip selects and bails out when there's nothing found on a chip
> select. This means the current code never finds the chip on CS2 since it
> already bails out after probing the empty CS1.
> 
> Any preferences how this should be handled? I could implement a i.MX6
> specific mapping function, possibly initialized from the device tree, to
> map the real chip selects to contiguous chip selects for the NAND layer.
> 
> Normally such a function should not be needed since we could autodetect
> if a chip select has a device connected or not, so the NAND layer could
> handle this without driver intervention, but is that what we want?
> 
> Any ideas/opinions?

This is a common mistake, caused by a poor documentation of what
nand->numchips and the chip argument passed to ->select_chip() are
representing. I'm not even sure I have the correct answer, but here is
my understanding (and last time I discussed it with Brian he seemed to
agree).

'struct nand_chip' is representing a single NAND chip not the NAND
controller, so, if you have 2 chips on your board, then your NAND
controller driver should instantiate 2 nand chips. and register both of
them to the NAND framework.
The only case where you'll need to specify numchips > 1 is when you
have a NAND chip stacking several dies, each of them accessible with
its own CS line.
In this case, the mapping between the controller CS line and the chip
CS line should be done by the NAND controller driver.
If you take your particular imx6 case, the mapping between the
chip and controller CS lines should be defined somewhere in the DT.

You can have a look at this binding [1] if you need an example, and if
I extend it for the multi-die case, it gives something like that:

nfc: nand at 01c03000 {
	compatible = "allwinner,sun4i-a10-nand";

	/* ... */
	#address-cells = <1>;
	#size-cells = <0>;

	nand at 0 {
		reg = <0 2>; /* CS0 and CS2 */
		allwinner,rb = <0 2>; /* RB0 and RB2 */
		/* ... */
	};

	nand at 1 {
		reg = <1>; /* CS1 */
		allwinner,rb = <1>; /* RB0 and RB2 */
		/* ... */
	};
};

I hope this helps.

Best Regards,

Boris

[1]http://lxr.free-electrons.com/source/Documentation/devicetree/bindings/mtd/sunxi-nand.txt


-- 
Boris Brezillon, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com