[PATCH v2 0/3] mtd: nand: introduce a READMODE command

[Gerhard Sittig]

On Mon, 2014-05-05 at 15:29 +0200, Gerhard Sittig wrote:
> 
> On Mon, 2014-04-14 at 20:55 +0200, Gerhard Sittig wrote:
> > 
> > On Fri, 2014-04-04 at 13:45 +0200, Gerhard Sittig wrote:
> > > 
> > > this series does some minor cleanup in nand_command_lp() and then
> > > introduces a NAND_CMD_READMODE opcode which is similar to the existing
> > > NAND_CMD_READ0 but does not imply NAND_CMD_READSTART
> > > 
> > > such a READMODE command is useful in preparation of the pending
> > > introduction of on-die-ECC support
> > 
> > Are there any concerns left that I should address?
> 
> There have been two good weeks without further comments, and an
> ACK from Gupta Pekon.  Can the series get applied?  Should I
> re-submit with the ACK?

Are there any remaining concerns that I shall address?  Can the
series get picked up?  Shall I re-send?  Thank you for checking!


virtually yours
Gerhard Sittig
-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr. 5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de