[PATCH 0/1] Fix OMAP2 NAND ONFI device detection

[Brian Norris]

Hi Ezequiel,

Dragging up an old piece of the conversation, but I think this
highlights some of the difficulty we're still having. Perhaps I should
have headed this off a month ago...

On Wed, Oct 30, 2013 at 08:19:57PM -0300, Ezequiel Garcia wrote:
> On Wed, Oct 30, 2013 at 09:18:53PM +0000, Gupta, Pekon wrote:
> > > 
> > > I'm not sure, of course, but I don't see why not. It's more likely to
> > > break for x16 than it is for x8.
> > > 
> > Another question here is ..
> > The above patch assumes that user has configured GPMC bus-width
> > correctly, so if user is already providing GPMC bus-width information
> > via DT, then do we really need to detect NAND device bus-width again
> > using NAND_BUSWIDTH_AUTO ?
> >
> 
> Hm.. I think you're forgetting the original motivation for this patch,
> which was initially explained by you :-) The problem is ONFI doesn't work
> in 16-bit mode.

So fix our ONFI detection code! Uwe's patch has helped reinforce what I
believe (but can't test yet, as I have no x16 hardware): that we can
*fix* the ONFI code so that it doesn't matter what bus width "mode" we
are in, but we can *always* identify the lower 8 bits of the bus.

> Let me clarify. Since GPMC and NAND widths *must* match (otherwise, it
> wouldn't make much sense, right?) we don't really need to autodetect the
> NAND width.

The rest of your argument should be trimmed here. Your following
comments are seemingly a hack to get around the fact that we don't
support ONFI correctly. But I think we should take a look at Uwe's
approach before going this far on a hack.

> However, since ONFI doesn't work in 16-bit mode, we would have to do
> something like this (untested pseudo code):
> 
>   nand_scan_ident(...);
> 
>   if (platform_data->devsize == 16)
>   	nand_chip->options |= NAND_BUSWIDTH_16;
> 
> And in some cases we might even get away with such solution. However,
> we can't guarantee nand_scan_ident() doesn't need to swith to 16-bit mode
> inside to perform other commands (maybe some ONFI extended parameter page).

(ONFI extended parameter page is only on the lower 8 bits too. So no
"16-bit mode" there.)

> I must admit I'm a bit puzzled by seeing most drivers setting 16-bit
> before calling nand_scan_ident(). I guess none of them relies on ONFI?

I'm fairly confident that most of those drivers have never been used
with a 16-bit bus width since the introduction of ONFI. I believe x16 is
much less common than x8, and there are probably several drivers that
get little or no use anyway. I think the closest we got to testing
results was when a developer complained about this line in the ONFI
code:

	WARN_ON(chip->options & NAND_BUSWIDTH_16);

resulting in commit 0ce82b7f7b7373b16ecf7b5725e21e2975204500. (It's
notable Paul was using similar hardware to you and Pekon...)

Brian