[PATCH] mtd-nand: davinci: correct 4-bit error correction

[Sudhakar Rajashekhara]

On Sat, Jul 10, 2010 at 04:09:32, Andrew Morton wrote:
> On Fri,  9 Jul 2010 10:59:49 +0530
> Sudhakar Rajashekhara <sudhakar.raj at ti.com> wrote:
> 
> > +
> > +	/*
> > +	 * ECC_STATE field reads 0x3 (Error correction complete) immediately
> > +	 * after setting the 4BITECC_ADD_CALC_START bit. So if you immediately
> > +	 * begin trying to poll for the state, you may fall right out of your
> > +	 * loop without any of the correction calculations having taken place.
> > +	 * The recommendation from the hardware team is to wait till ECC_STATE
> > +	 * reads less than 4, which means ECC HW has entered correction state.
> > +	 */
> > +	do {
> > +		ecc_state = (davinci_nand_readl(info,
> > +				NANDFSR_OFFSET) >> 8) & 0x0f;
> > +		cpu_relax();
> > +	} while ((ecc_state < 4) && time_before(jiffies, timeo));
> 
> An up-to-100-milliseond busy wait is pretty bad.  For how long do you
> expect this to spin in practice?

On the hardware, I have never seen this taking 100 msec to come out of
the loop. I'll check with the hardware folks on the maximum time to wait
for, before the ECC engine is ready.

Thanks,
Sudhakar