[PATCH] drm/mediatek: mtk_dsi: enable hs clock during pre-enable

[Chun-Kuang Hu]

Hi, Gary:

Gary Bisson <bisson.gary at gmail.com> 於 2026年1月20日週二 上午11:37寫道：
>
> Some bridges, such as the TI SN65DSI83, require the HS clock to be
> running in order to lock its PLL during its own pre-enable function.
>
> Without this change, the bridge gives the following error:
> sn65dsi83 14-002c: failed to lock PLL, ret=-110
> sn65dsi83 14-002c: Unexpected link status 0x01
> sn65dsi83 14-002c: reset the pipe
>
> Move the necessary functions from enable to pre-enable.

Applied to mediatek-drm-next [1], thanks.

[1] https://git.kernel.org/pub/scm/linux/kernel/git/chunkuang.hu/linux.git/log/?h=mediatek-drm-next

Regards,
Chun-Kuang.

>
> Signed-off-by: Gary Bisson <bisson.gary at gmail.com>
> ---
> Tested on Tungsten510 module with sn65dsi83 + tm070jdhg30 panel.
>
> Left mtk_dsi_set_mode() as part of the enable function to mimic what is
> done in the Samsung DSIM driver which is known to be working the TI
> bridge.
> ---
>  drivers/gpu/drm/mediatek/mtk_dsi.c | 35 +++++++++++++++++------------------
>  1 file changed, 17 insertions(+), 18 deletions(-)
>
> diff --git a/drivers/gpu/drm/mediatek/mtk_dsi.c b/drivers/gpu/drm/mediatek/mtk_dsi.c
> index 0e2bcd5f67b7..b560245d1be9 100644
> --- a/drivers/gpu/drm/mediatek/mtk_dsi.c
> +++ b/drivers/gpu/drm/mediatek/mtk_dsi.c
> @@ -672,6 +672,21 @@ static s32 mtk_dsi_switch_to_cmd_mode(struct mtk_dsi *dsi, u8 irq_flag, u32 t)
>         }
>  }
>
> +static void mtk_dsi_lane_ready(struct mtk_dsi *dsi)
> +{
> +       if (!dsi->lanes_ready) {
> +               dsi->lanes_ready = true;
> +               mtk_dsi_rxtx_control(dsi);
> +               usleep_range(30, 100);
> +               mtk_dsi_reset_dphy(dsi);
> +               mtk_dsi_clk_ulp_mode_leave(dsi);
> +               mtk_dsi_lane0_ulp_mode_leave(dsi);
> +               mtk_dsi_clk_hs_mode(dsi, 0);
> +               usleep_range(1000, 3000);
> +               /* The reaction time after pulling up the mipi signal for dsi_rx */
> +       }
> +}
> +
>  static int mtk_dsi_poweron(struct mtk_dsi *dsi)
>  {
>         struct device *dev = dsi->host.dev;
> @@ -724,6 +739,8 @@ static int mtk_dsi_poweron(struct mtk_dsi *dsi)
>         mtk_dsi_set_vm_cmd(dsi);
>         mtk_dsi_config_vdo_timing(dsi);
>         mtk_dsi_set_interrupt_enable(dsi);
> +       mtk_dsi_lane_ready(dsi);
> +       mtk_dsi_clk_hs_mode(dsi, 1);
>
>         return 0;
>  err_disable_engine_clk:
> @@ -769,30 +786,12 @@ static void mtk_dsi_poweroff(struct mtk_dsi *dsi)
>         dsi->lanes_ready = false;
>  }
>
> -static void mtk_dsi_lane_ready(struct mtk_dsi *dsi)
> -{
> -       if (!dsi->lanes_ready) {
> -               dsi->lanes_ready = true;
> -               mtk_dsi_rxtx_control(dsi);
> -               usleep_range(30, 100);
> -               mtk_dsi_reset_dphy(dsi);
> -               mtk_dsi_clk_ulp_mode_leave(dsi);
> -               mtk_dsi_lane0_ulp_mode_leave(dsi);
> -               mtk_dsi_clk_hs_mode(dsi, 0);
> -               usleep_range(1000, 3000);
> -               /* The reaction time after pulling up the mipi signal for dsi_rx */
> -       }
> -}
> -
>  static void mtk_output_dsi_enable(struct mtk_dsi *dsi)
>  {
>         if (dsi->enabled)
>                 return;
>
> -       mtk_dsi_lane_ready(dsi);
>         mtk_dsi_set_mode(dsi);
> -       mtk_dsi_clk_hs_mode(dsi, 1);
> -
>         mtk_dsi_start(dsi);
>
>         dsi->enabled = true;
>
> ---
> base-commit: 8f0b4cce4481fb22653697cced8d0d04027cb1e8
> change-id: 20260120-mtkdsi-29e4c84e7b38
>
> Best regards,
> --
> Gary Bisson <bisson.gary at gmail.com>
>