[PATCH v13 13/14] drm/mediatek: dpi: Add dp_intf support

Rex-BC Chen rex-bc.chen at mediatek.com
Wed Jun 22 02:10:55 PDT 2022


On Tue, 2022-06-21 at 14:11 +0200, AngeloGioacchino Del Regno wrote:
> Il 21/06/22 13:37, Bo-Chen Chen ha scritto:
> > From: Guillaume Ranquet <granquet at baylibre.com>
> > 
> > Dpintf is the displayport interface hardware unit. This unit is
> > similar
> > to dpi and can reuse most of the code.
> > 
> > This patch adds support for mt8195-dpintf to this dpi driver. Main
> > differences are:
> >   - 4 pixels for one round for dp_intf while dpi is 1 pixel for one
> > round.
> >     Therefore, we add a new config "round_pixels" to control
> > setting of
> 
> Okay, I like where this is going, but "round_pixels" explains itself
> like
> "the pixels are round" (which doesn't make sense).
> 
> So... is this "4 pixels per iteration" (computation of 4 pixels per
> iteration),
> or "outputs 4 pixels at a time"?
> I can give you some ideas about a better name for this struct member,
> I think...
> ...something like "output_4pixel"?
> 
> Alternatively, we can do something even cleaner here:
> u8 pixels_per_round;
> 
> ...where we define it like...
> 
> static const struct mtk_dpi_conf mt8195_dpintf_conf = {
> 	.pixels_per_round = 4,
> 	..........
> }
> 
> static const struct mtk_dpi_conf mt8192_conf = {
> 	.pixels_per_round = 1,
> 	.........
> }
> 
> ... and then, in function mtk_dpi_set_display_mode(), we would have
> something like
> 
> 	/*
> 
> 	 * Depending on the IP version, we may output a different
> amount
> 
> 	 * of pixels for each (choose: round/iteration): divide the
> clock
> 
> 	 * by this number and adjust the display porches accordingly.
> 
> 	 */
> 
>     	vm.pixelclock = pll_rate / factor;
> 
> 	vm.pixelclock /= dpi->conf->pixels_per_round;
> 
> 
> 
> 	......
> 
> 
> 
>     	hsync.sync_width = vm.hsync_len / dpi->conf->pixels_per_round;
> 
>     	hsync.back_porch = vm.hback_porch / dpi->conf-
> >pixels_per_round;
> 
>     	hsync.front_porch = vm.hfront_porch / dpi->conf-
> >pixels_per_round;
> 
> This would also eliminate any need to check if the IP has 4 pixels
> per round
> or if it has just 1, as in the latter case, we'd be dividing by 1
> (hence, we
> would not be dividing anything).
> 
> Do you like this solution? :-)
> 
> Cheers,
> Angelo
> 

Hello Angelo,

Thanks for the advise!
After syncing with CK, I will use mothod of "pixels_per_round".
This soultion is pretty good and more clear for this config.

Thanks again!

BRs,
Bo-Chen

> >     pixel clock and timing parameter for dp_intf.
> >   - Input of dp_intf is two pixels per round, so we add a new
> > config
> >     "input_2pixel" to control this.
> >   - Some register contents differ slightly between the two
> > components. To
> >     work around this I added register bits/masks with a DPINTF_
> > prefix
> >     and use them where different.
> > 
> > Based on a separate driver for dpintf created by
> > Jitao shi <jitao.shi at mediatek.com>.
> > 
> > Signed-off-by: Markus Schneider-Pargmann <msp at baylibre.com>
> > Signed-off-by: Guillaume Ranquet <granquet at baylibre.com>
> > [Bo-Chen: Modify reviewers' comments.]
> > Signed-off-by: Bo-Chen Chen <rex-bc.chen at mediatek.com>
> > ---
> >   drivers/gpu/drm/mediatek/mtk_dpi.c          | 62
> > +++++++++++++++++++++
> >   drivers/gpu/drm/mediatek/mtk_dpi_regs.h     | 12 ++++
> >   drivers/gpu/drm/mediatek/mtk_drm_ddp_comp.c |  4 ++
> >   drivers/gpu/drm/mediatek/mtk_drm_ddp_comp.h |  1 +
> >   drivers/gpu/drm/mediatek/mtk_drm_drv.c      |  3 +
> >   5 files changed, 82 insertions(+)
> > 
> > diff --git a/drivers/gpu/drm/mediatek/mtk_dpi.c
> > b/drivers/gpu/drm/mediatek/mtk_dpi.c
> > index ef7f828a4b1e..e562f0d55cc2 100644
> > --- a/drivers/gpu/drm/mediatek/mtk_dpi.c
> > +++ b/drivers/gpu/drm/mediatek/mtk_dpi.c
> > @@ -131,6 +131,11 @@ struct mtk_dpi_yc_limit {
> >    * @color_fmt_trans_support: Enable color format transfer.
> >    * @support_direct_pin: Dpi can directly connect pins, and enable
> > this config
> >    *			to do this.
> > + * @round_pixels: Dp_intf is 4 pixels for one round while dpi is
> > one pixel for
> > + *		  one round, so we need to enable this config for
> > dp_intf to do
> > + *		  corresponding settings.
> > + * @input_2pixel: Input pixel of dp_intf is 2 pixel per round, so
> > enable this
> > + *		  config to enable this feature.
> >    * @dimension_mask: Mask used for HWIDTH, HPORCH, VSYNC_WIDTH and
> > VSYNC_PORCH
> >    *		    (no shift).
> >    * @hvsize_mask: Mask of HSIZE and VSIZE mask (no shift).
> > @@ -149,6 +154,8 @@ struct mtk_dpi_conf {
> >   	bool swap_input_support;
> >   	bool color_fmt_trans_support;
> >   	bool support_direct_pin;
> > +	bool round_pixels;
> > +	bool input_2pixel;
> >   	u32 dimension_mask;
> >   	u32 hvsize_mask;
> >   	u32 channel_swap_shift;
> > @@ -560,6 +567,14 @@ static int mtk_dpi_set_display_mode(struct
> > mtk_dpi *dpi,
> >   	pll_rate = clk_get_rate(dpi->tvd_clk);
> >   
> >   	vm.pixelclock = pll_rate / factor;
> > +
> > +	/*
> > +	 * For dp_intf, we need to divide clock by 4 because it's
> > +	 * 4 pixels for one round while dpi is 1 pixel for one round.
> > +	 */
> > +	if (dpi->conf->round_pixels)
> > +		vm.pixelclock /= 4;
> > +
> >   	if ((dpi->output_fmt == MEDIA_BUS_FMT_RGB888_2X12_LE) ||
> >   	    (dpi->output_fmt == MEDIA_BUS_FMT_RGB888_2X12_BE))
> >   		clk_set_rate(dpi->pixel_clk, vm.pixelclock * 2);
> > @@ -581,6 +596,17 @@ static int mtk_dpi_set_display_mode(struct
> > mtk_dpi *dpi,
> >   	hsync.sync_width = vm.hsync_len;
> >   	hsync.back_porch = vm.hback_porch;
> >   	hsync.front_porch = vm.hfront_porch;
> > +
> > +	/*
> > +	 * For dp_intf, we need to divide everything by 4 because it's
> > +	 * 4 pixels for one round while dpi is 1 pixel for one round.
> > +	 */
> > +	if (dpi->conf->round_pixels) {
> > +		hsync.sync_width = vm.hsync_len / 4;
> > +		hsync.back_porch = vm.hback_porch / 4;
> > +		hsync.front_porch = vm.hfront_porch / 4;
> > +	}
> > +
> >   	hsync.shift_half_line = false;
> >   	vsync_lodd.sync_width = vm.vsync_len;
> >   	vsync_lodd.back_porch = vm.vback_porch;
> > @@ -629,6 +655,10 @@ static int mtk_dpi_set_display_mode(struct
> > mtk_dpi *dpi,
> >   		mtk_dpi_dual_edge(dpi);
> >   		mtk_dpi_config_disable_edge(dpi);
> >   	}
> > +	if (dpi->conf->input_2pixel) {
> > +		mtk_dpi_mask(dpi, DPI_CON, DPINTF_INPUT_2P_EN,
> > +			     DPINTF_INPUT_2P_EN);
> > +	}
> >   	mtk_dpi_sw_reset(dpi, false);
> >   
> >   	return 0;
> > @@ -869,6 +899,16 @@ static unsigned int
> > mt8183_calculate_factor(int clock)
> >   		return 2;
> >   }
> >   
> > +static unsigned int mt8195_dpintf_calculate_factor(int clock)
> > +{
> > +	if (clock < 70000)
> > +		return 4;
> > +	else if (clock < 200000)
> > +		return 2;
> > +	else
> > +		return 1;
> > +}
> > +
> >   static const u32 mt8173_output_fmts[] = {
> >   	MEDIA_BUS_FMT_RGB888_1X24,
> >   };
> > @@ -878,6 +918,11 @@ static const u32 mt8183_output_fmts[] = {
> >   	MEDIA_BUS_FMT_RGB888_2X12_BE,
> >   };
> >   
> > +static const u32 mt8195_output_fmts[] = {
> > +	MEDIA_BUS_FMT_RGB888_1X24,
> > +	MEDIA_BUS_FMT_YUYV8_1X16,
> > +};
> > +
> >   static const struct mtk_dpi_conf mt8173_conf = {
> >   	.cal_factor = mt8173_calculate_factor,
> >   	.reg_h_fre_con = 0xe0,
> > @@ -943,6 +988,20 @@ static const struct mtk_dpi_conf mt8192_conf =
> > {
> >   	.csc_enable_bit = CSC_ENABLE,
> >   };
> >   
> > +static const struct mtk_dpi_conf mt8195_dpintf_conf = {
> > +	.cal_factor = mt8195_dpintf_calculate_factor,
> > +	.max_clock_khz = 600000,
> > +	.output_fmts = mt8195_output_fmts,
> > +	.num_output_fmts = ARRAY_SIZE(mt8195_output_fmts),
> > +	.round_pixels = true,
> > +	.input_2pixel = true,
> > +	.dimension_mask = DPINTF_HPW_MASK,
> > +	.hvsize_mask = DPINTF_HSIZE_MASK,
> > +	.channel_swap_shift = DPINTF_CH_SWAP,
> > +	.yuv422_en_bit = DPINTF_YUV422_EN,
> > +	.csc_enable_bit = DPINTF_CSC_ENABLE,
> > +};
> > +
> >   static int mtk_dpi_probe(struct platform_device *pdev)
> >   {
> >   	struct device *dev = &pdev->dev;
> > @@ -1065,6 +1124,9 @@ static const struct of_device_id
> > mtk_dpi_of_ids[] = {
> >   	{ .compatible = "mediatek,mt8192-dpi",
> >   	  .data = &mt8192_conf,
> >   	},
> > +	{ .compatible = "mediatek,mt8195-dp-intf",
> > +	  .data = &mt8195_dpintf_conf,
> > +	},
> >   	{ },
> >   };
> >   MODULE_DEVICE_TABLE(of, mtk_dpi_of_ids);




More information about the Linux-mediatek mailing list