[PATCH RFC net-next 0/7] net: dsa: mt7530: updates for phylink changes
Landen Chao
landen.chao at mediatek.com
Wed Feb 9 09:33:34 PST 2022
On Wed, 2022-02-09 at 21:06 +0800, Russell King (Oracle) wrote:
> On Thu, Feb 03, 2022 at 05:30:31PM +0000, Russell King (Oracle)
> wrote:
> > Hi,
> >
> > This series is a partial conversion of the mt7530 DSA driver to the
> > modern phylink infrastructure. This driver has some exceptional
> > cases
> > which prevent - at the moment - its full conversion (particularly
> > with
> > the Autoneg bit) to using phylink_generic_validate().
> >
> > What stands in the way is this if() condition in
> > mt753x_phylink_validate():
> >
> > if (state->interface != PHY_INTERFACE_MODE_TRGMII ||
> > !phy_interface_mode_is_8023z(state->interface)) {
> >
> > reduces to being always true. I highlight this here for the
> > attention
> > of the driver maintainers.
Hi Russel,
The above behaviour is really a bug. "&&" should be used to prevent
setting MAC_10, MAC_100 and Antoneg capability in particular interface
mode in original code. However, these capability depend on the link
partner of the MAC, such as Ethernet phy. It's okay to keep setting
them.
Thanks for this series.
>
> I'm intending to submit this series later today, preserving the above
> behaviour, as I like to keep drivers bug-for-bug compatible, with the
> assumption that they've been tested as working, even if the code
> looks
> wrong. However, it would be good if this point could be addressed.
> Thanks.
>
More information about the Linux-mediatek
mailing list