arm gpio setting

[Subramani Venkatesh]

This email is so noisy, you have been sending it repeatedly ..

On Thu, May 13, 2010 at 5:42 AM, sneha prakash <sneghu at gmail.com> wrote:

> Hi ,
>         We are using i.mx 25 board which consists of arm9 controller.I
> need to
>         convert the CMOS connector in the board to parallel port pins.We
> have to
>         convert CMOS connector pins to GPIO pins using IOMUX
> configuration.Could
>         any one help me to configure GPIO pins as parallel port pins and to
> set
>         the base address.
> Regards,
>       sneha.
>
>
> _______________________________________________
> linux-arm mailing list
> linux-arm at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.infradead.org/pipermail/linux-arm/attachments/20100527/537b914d/attachment-0001.html>