[PATCH v5 3/3] arm64: dts: imx95: Add support for Data Modul i.MX95 eDM SBC

[Marek Vasut]

On 9/29/26 4:45 PM, Frank Li wrote:

Hello Frank,

>> +	backlight_lvds: backlight-lvds {
>> +		compatible = "pwm-backlight";
>> +		pinctrl-names = "default";
>> +		pinctrl-0 = <&pinctrl_panel_backlight_lvds>;
>> +		brightness-levels = <0 1 10 20 30 40 50 60 70 75 80 90 100>;
>> +		default-brightness-level = <7>;
>> +		enable-gpios = <&gpio2 27 GPIO_ACTIVE_HIGH>;
>> +		pwms = <&tpm3 3 5000000 0>;
>> +		/* Disabled by default, unless display board plugged in. */
>> +		status = "disabled";
>> +	};
> 
> The both backlight is not used in this dts, can you remove it and
> add these when it real use.
It's the same thing we do on the other boards, so I would prefer to keep 
this consistent:

arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts: 
backlight: backlight {
arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts: 
compatible = "pwm-backlight";
arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts- 
brightness-levels = <0 1 10 20 30 40 50 60 70 75 80 90 100>;
arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts- 
default-brightness-level = <7>;
arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts- 
pwms = <&pwm1 0 5000000 0>;
arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts- 
/* Disabled by default, unless display board plugged in. */
arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts- 
status = "disabled";
arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts-    };