[PATCH] arm64: dts: allwiner: h5: OrangePi PC2: add ethernet LEDs

[Aleksander Jan Bajkowski]

Hi Andre,
I see that my previous reply didn't reach lkml

On 09/09/2025 02:24, Andre Przywara wrote:
> On Mon, 18 Aug 2025 18:35:13 +0200
> Aleksander Jan Bajkowski <olek2 at wp.pl> wrote:
>
>> This patch adds support for Ethernet LEDs.
> So I tried this on my OPi-PC2, but I cannot influence the LEDs. I have
> CONFIG_LED_TRIGGER_PHY and CONFIG_LEDS_TRIGGER_NETDEV built in, and I
> see mdio_mux-0.2:01:amber:lan and mdio_mux-0.2:01:green:lan in
> /sys/class/leds, but anything I write into trigger does not seem to
> change the output: it always stays on the network functionality, I
> guess because it's still configured to the PHY hardware wired function?
>
> What am I missing?
>
>

You should also set up the name of the device that controls the activity:

Example:
root at OpenWrt:/sys/class/leds/mdio_mux-0.2:01:green:lan# echo "eth0" > 
device_name
root at OpenWrt:/sys/class/leds/mdio_mux-0.2:01:green:lan# echo "1" > link_10
root at OpenWrt:/sys/class/leds/mdio_mux-0.2:01:green:lan# echo "1" > 
link_1000
root at OpenWrt:/sys/class/leds/mdio_mux-0.2:01:amber:lan# echo "eth0" > 
device_name
root at OpenWrt:/sys/class/leds/mdio_mux-0.2:01:amber:lan# echo "1" > rx
root at OpenWrt:/sys/class/leds/mdio_mux-0.2:01:amber:lan# echo "1" > tx


In the second iteration, I added the default-spate = “keep” property. By 
default,
the LEDs will be activated as before.

Regards,
Aleksander